Hollow cone spray 1 22/6/01 10:46 pm Page 5 SPRAY CHARACTERISTICS q Finely atomised hollow cone spray pattern. q Nominal spray angle of 70° (45° and 80° to special order). CONSTRUCTION AND MATERIALS q q q q q q Four part design - nozzle body, strainer, tip and cap. Tip consists of body with orifice insert, distributor and screw pin. Tips are interchangeable and replaceable. Body thread sizes are Male BSPT and Female BSPP . 100 - mesh Stainless Steel strainers supplied on request. Brass with 416 Stainless Steel metering parts. ORDER EXAMPLE HC 5 = Tip Only. 1⁄4” HC 5 (Male) = Complete Assembly. 1⁄4” HC 10 (Female) = Complete Assembly. Assembly Dimensions (mm) Type A Hex B C Hex HOLLOW CONE SPRAY DIMENSIONS AND WEIGHTS Weight (g) 1⁄8 Female 20,8 47,7 18,0 1⁄8 Male 20,8 46,0 18,0 60 1⁄4 Female 20,8 47,7 18,0 70 1⁄4 Male 20,8 47,7 18,0 62 70 TYPE HC HC TYPE HC (MALE) ASSEMBLY HC (FEMALE) ASSEMBLY Maximum Recommended Pressure: 35 Bar.G. CAPACITY CHART NOZZLE NUMBER FLOW RATE IN LITRES/HOUR AT Bar.G. 4 5 2 3 6 7 HC 1,0 3,23 3,95 4,56 5,10 5,58 6,03 HC 1,25 4,03 4,93 5,70 6,37 6,98 7,54 HC 1,50 4,84 5,92 6,84 7,64 8,37 9,04 HC 2,0 6,45 7,89 9,12 10,2 11,2 12,1 HC 2,5 8,05 9,57 11,4 12,7 14,0 15,1 HC 3,0 9,65 11,8 13,7 15,3 16,7 18,0 HC 4,0 12,9 15,8 18,2 20,4 22,3 24,1 HC 5,0 16,1 19,7 22,8 25,5 27,9 30,1 HC 6,0 19,3 23,7 27,3 30,6 33,5 36,2 HC 8,0 25,8 31,6 36,5 40,8 44,7 48,3 HC 10,0 32,2 39,5 45,6 51,0 55,8 60,3 HC 12,0 38,6 47,4 54,7 61,1 67,0 72,4 HC 14,0 45,1 55,3 63,8 71,3 78,1 84,4 HC 18,0 58,0 71,0 82,0 91,7 100 108 HC 22,0 71,0 86,8 100 112 123 133 HC 26,0 84,0 103 119 132 145 157 Contact our Helpline for any special requirements: Tel: +44 (0) 151 424 6821 Fax: +44 (0) 151 495 1043 e-mail:[email protected] Web:www.delavan.co.uk B.5