LODOS GAS UNIT HEATERS TECHNICAL DOCUMENTATION MANUFACTURER Daygas Heating Systems İnş. Tah. Ltd. Sti. Firuzköy Bulvarı No: 206, 34325 Avcilar / Istanbul 0 (850) 532 91 53 - 0 (212) 423 30 44 Avcilar VD. - 271079683

Lodos Gas Unit Heater Series Lodos Gas Unit Heater Series Daygas Lodos gas unit heater use the heat energy obtained from NG or LPG, thanks to the fan on them.They are devices that provide heating by blowing hot air directly or through air ducts to the environment to be heated. Daygas Lodos hot air generator devices provide high efficiency and low energy consumption thanks to the specially designed boiler structure. Custom design it is the product with the lowest operating noise with its boiler and body structure. Noise levels are measured from 6 meters away. It works quieter than its counterparts....

Lodos Design Product Hardware Custom Daygas Motherboard Lodos motherboards are engineering designs with their own software, operation and quality, as in other Daygas products.This card works on homogeneous heat distribution and maximum efficiency in the environment where Lodos devices are located. LIGHTERING GROUND IONIZERS AXIAL FAN FLUE MORTAL PHASE NEUTRAL Main; Confirming the error as a result of receiving error alarms for the capacity and fan speed ratio as a result of comparing the ambient air temperature (suction port temperature) with the set temperature, first-start and last-operation...

Lodos Design Product Hardware Heat Exchanger Lodos series heat exchangers are made of high temperature and resistant stainless steel sheet for full capacity and uninterrupted service. With the specially designed thousands of fins on the heat exchanger, the air passing through the unit volume is more in contact with the hot surface area and the blowing temperature up to 120°C is obtained in front of the device. Axial Fan The axial fan located behind the lodos is used to condition the air (heating the circulated air in the environment through the heat exchanger cavity). Importance of Ideal Fan...

Exhaust Flue Set Accessories Hot air generators positioning is as important as device capacity selection. Since the heating takes place conventionally here, the ambient air circulation and the intensity of the hot air blowing to the coldest parts of the space are directed to these cold regions, thereby providing homogeneous comfort conditions. Rain Protected Hat Master Flash While the flue gas flue pipes are positioned Wall Fixing vertically to exit from the roof, vertical mounting Clamps should be made with fixing clamps from the joint points of the chimneys. Rain protection cap with sealing...

Lodos Positioning Design Hot air generators positioning is as important as device capacity selection. Since the heating takes place conventionally here, the ambient air circulation and the intensity of the hot air blowing to the coldest parts of the space are directed to these cold regions, thereby providing homogeneous comfort conditions. If we examine the example of the cafeteria next door, the coldest part of the place is the glass facade. Therefore, we should direct the hot air density towards these cold regions. Lodoslar, which has been positioned in the project, starts to heat from the...

Lodos Positioning Design Lodos 35 Mounting Space Roof Exhaust In the example above, a 3rd device is positioned to feed 2 Lodos devices that are back to back to each other. This 3rd device is important for the environment to have a faster or homogeneous heat distribution by strengthening the ambient air circulation. In high ceiling spaces where the ceiling height is not suitable for the hot air generator, the desired heating cannot be achieved because the air mass is in the upper part as a result of the circulation caused by the rising of the heated air, and the temperature of the lower part is...

Radial Fan Gas Unit Heater In duct type air heating applications, ambient air heating and ventilation are performed through the blowing nozzles. Lodos can change the fan structure of gas unit heater to a radial fan and feed the duct, and it undertakes the task ofefficient heating in winter conditions and ventilation in summer months when it is not very hot. The design is made by selecting the capacity as a result of some engineering calculations such as the radial fan, the volume of the air duct to be conditioned, and the blowing nozzle. Flammable, explosive and flammable etc. We offer safe and...

Electrical and Signal Cables Connection Details » In Lodos devices, as in other product groups, 1.5 m F type cable set for electrical connection is included in the box for each device. » There is a 2A glass fuse at the device electrical connection point (in the C14 socket part) to protect the device board. Therefore, the cards of the devices are protected against sudden electrical voltages on the power line. Lodos Sıcak Hava Üreteci; Electrical Connection: 230 V / 50 Hz Electrical Working Power: ≤ 300 VA

MANUFACTURER Daygas Heating Systems İnş. Tah. Ltd. Sti. Firuzköy Bulvarı No: 206, 34325 Avcilar / Istanbul 0 (850) 532 91 53 - 0 (212) 423 30 44 Avcilar VD. - 2710796836