ELECTRONIC AND CONTROL PROCESS DEVICES DAT5028-DAT5024 SERIES: Trip amplifiers for DIN rail mounting The devices of the “DAT5028 - DAT5024” series can accept on input several types of sensor coming from the field. • TRIP AMPLIFIERS with universal analog input configurable by Dip-switch indication on display of the trip level value (DAT5028) • TRIP AMPLIFIERS with dedicated analog input (DAT5024) • TRIP AMPLIFIERS with configurable input Voltage or Current (DAT5024E) Trip amplifier with display for universal analog input 41 • DAT 5024 Trip amplifier with dedicated analog input Economic, isolated trip amplifier configurable by

Trip “DAT5028 / DAT5024 series” trip amplifiers amplifiers for DIN rail mounting TRIP AMPLIFIERS

TRIP AMPLIFIER WITH DISPLAY FOR UNIVERSAL ANALOG INPUT GENERAL DESCRIPTION The DAT 5028 device is able to acquire RTD or Tc sensors, mV, V or mA input signals connected to the universal analog input. By means of push-button and 4-digit display on the front panel, four different trip alarms are configurable. Each alarm threshold commands an output relay. Input signal can be retransmitted on the analog output in a Voltage or Current signal, configurable by means of dip-switch on the side of the device. By means of an internal 16 bit converter, the device guarantees high accuracy and a stable measure...

CDDAlEXEL GENERAL DESCRIPTION The trip amplifier DAT 5024 is able to accept on its input a wide range of normalised voltage signals, normalised current signals coming from both active and passive current loop, signals coming from RTDs, Thermocouples and resistance sensors. The input type and the input range are fixed: refer to the section "Technical Specifications”, table " Input type ” to order the device. The Threshold 1 is programmed as high alarm, while, by dip-switches, it is possible to set the Threshold 2 either as high or low alarm. The trip level of each threshold can be adjusted by...

ECONOMIC, ISOLATED TRIP AMPLIFIER CONFIGURABLE BY DIP-SWITCHES GENERAL DESCRIPTION The DAT 5024E is an economic trip amplifier able to accept on its input normalised voltage and current signals coming from both active and passive current loops. Both the trips can be configured as high or low alarm, the adjustment of the trip values is performed by the potentiometers THR1 and THR2 located on the front side of the device. The adjustment of the hysteresis and delay value can be performed by the potentiometers accessible opening the suitable door located on the side of the device. On the devices...

TRIP AMPLIFIERS ELECTRONIC AND CONTROL PROCESS DEVICES “DAT5028 / DAT5024 series” trip amplifiers for din rail mounting Application areas