DM1200ID-CD3000Ultra-stable, high precision (ppm class) fluxgate technology DM Series current transducer for non-intrusive, isolated DC and AC current measurement up to 1500AFeatures Applications: 045mm aperture enabling large isolated cables and the possibility to measure leakage current at high precision. Stable power supplies MPS for particles accelerators 3 ppm linearity, 12 ppm offset Current output Batteries testing and evaluation systems Current calibration—Metrology Fluxgate, closed loop compensated technology with crystal driven excitation frequency for increased stability Access to 3000 turns calibration winding in DSUB Possibility to perform 1500A calibration with 500mA source through calibration winding of 3000 turns Not suitable for frequencies above 15kHz due to calibration winding Specification highlights All ppm (or %) values refer to nominal current Precision - Innovation www.danisense.com

DM1200ID-CD3000Electrical specifications at Ta=23°C, supply voltage = ± 15V unless otherwise stated Parameter Precision - Innovation www.danisense.com

Maximum measurement resistor Value (Ohm) Maximum measurement resistor vs. ambient temperatures 10 8 Primary Current, DC or peak (A) R_max_25 Maximum primary current Arms 1000 Primary Current (Hz) Max current (Arms) 25 deg Precision – Innovation www.danisense.com

Precision - Innovation www.danisense.com

DM1200ID-CD3000 Advanced Sensor Protec琀椀on Circuits “ASPC” Developed to protect the current transducer from typical fault condi琀椀ons: • Unit is un-powered and secondary circuit is open or closed • Unit is powered and secondary circuit is open or interrupted Both DC and AC primary current up to 100% of nominal value can be applied to the current transducers in the above situa琀椀ons without damage to the electronics. Please no琀椀ce that the sensor core can be magne琀椀zed in all above cases, leading to a small change in output o昀昀set current (less than 10ppm) Status pins When transducer is opera琀椀ng...

Dimension in mm (general tolerance 0.3mm unless otherwise stated) DSUB-9 current output with calibration winding -Vc +Vc 0V Status (Optical Isolated) Status (optical isolated) Calibration current + Calibration current I (Out+) I (Out-) When sensor is operating in normal condition the status pins are shorted. Status pin properties. - Forward direction pin 8 to pin 3 - Maximum forward current 10mA - Maximum forward voltage 60V - Maximum reverse voltage 5V Posi琀椀ve current direc琀椀on Is iden琀椀昀椀ed by an arrow on the transducer body Base plate moun琀椀ng: 4 slo琀琀ed holes Ø6 mm Back plate moun琀椀ng: 4...

DM1200ID-CD3000 Declaration of Conformity Danisense A/S Malervej 10 DK-2630 Taastrup Denmark Declares that under our sole responsibility that this product is in conformity with the provisions of the following EC Directives, including all amendments, and with national legislation implementing these directives: Directive 2014/30/EU Directive 2014/35/EU And that the following harmonized standards have been applied EN 61010-1 (Third Edition):2010, EN 61010-1:2010/A1:2019 EN 61010-2-030:2021/A11:2021 EN 61326-1:2013 All DANISENSE products are manufactured in accordance with RoHS directive 2011/65/EU....