WS103
2Pages

MAKING MODERN LIVING POSSIBLE Data Sheet WS103 Remote solution Remote connection to PLUS+1® mobile machine control systems The Danfoss WS103 Remote Solution is Plug and Perform compliant with the PLUS+1® family of mobile machine management products. The WS103 allows PLUS+1® Service Tool wireless access to a mobile machine’s PLUS+1® control system. The WS103 provides the same functionality that is available when a laptop running the PLUS+1® Service Tool is directly connected to the machine using the Danfoss CG150 CAN/USB Gateway or WS403 Remote Solution. Wireless communication The WS103 Remote Solution consists of a wireless CAN interface with internal antenna. The WS103 plugs into the machine’s CAN communication bus and may be permanently mounted on the machine or used as a temporary diagnostic tool. WS103 device drivers are embedded in the PLUS+1® Service Tool. Remote machine control access The WS103 allows wireless upload and download of machine application tuning parameters, wireless downloads of application software to machine PLUS+1® controllers and displays and wireless access to machine vault memory. yy Easy-to-Install enclosure yy Plug and Perform integration with PLUS+1® Service Tool yy Supports temporary or permanent machine installation yy Wireless Transfer of CAN Bus Data between CAN bus network and/or WLAN/LAN networks yy Wireless data transfer via WLAN yy High data transfer rate, wireless data transfer yy Interfaces with programmable PLUS+1® compliant hardware to: –– View checkpoint data –– Upload and download parameters –– Reflash applications –– Read vault memory • Multiradio Wireless device Wi-Fi IEEE 802.11-2012 (abgn), Dual Band Wi-Fi 2.4 & 5 Ghz, Dual-mode Bluetooth 4.0, IPv4 and limited IPv6, Micro access point solution • 1 RS232 for WS103 configuration and FW update • and Android connectivity, designed for iOS IoT - Internet-of-Things • CAN bus (ISO 11898-2 High Speed, 2.0A/B) 1 supports machine CAN bus bit rates up to 1 MB per second yy CE, E1, FCC IC, MIC/TELEC certification compliant (planned) yy Remote Solution Kit includes wireless gateway and cable and protection cap yy IP 67 protection degree yy More efficient and dependable than cables over long runs and moving joints; Increases reliability by removing the cables, a failure entry point within many control systems yy Access to CAN data, the device enable to display, monitor, record and analyze data of mobile and stationary CAN bus systems from anywhere yy WS103 supports standard and sleep (energy saving) power modes yy Reduces field service, EOL FW installation and maintenance costs yy Gives system designers a reliable link between two CAN interfaces yy The software WS System Tool enables the user to easily adapt the configuration of WS103 to the most diverse applications

Data Sheet Power supply Power supply Dig-IN / Terminal 15 Input (ignition) CAN Connector J-1 (left side – top view) M12, 5pin, A-coded male pinouts Power supply Power supply Boot-pin, RS-232 Data Set Ready (input) RS-232 Connector J-2 (right side-top view) M12, 5pin, A-coded male pinouts P301 873.A Mechanical data Device Type Standard housing Operating Temperature range Device type Part numbers Storage Temperature range IP 67 with all connectors plugged in Part numbers Status LEDs (2 colors) Mating Connector Part numbers CAN cable M12 5pin / open – 5m cable Related products and kits Part...