VERTICAL GUARDRAILS
4Pages

VERTICAL GUARDRAILS Intended to prevent people falling at different levels during the construction of enclosures by establishing a perimeter edge protection. Applicable in concrete walls (min. thickness 15cm), masonry (min. 20cm), works (min. 20cm) and prefabricated concrete (min. 20cm). Vertical Guardrails are available with railing PT support in clamp format with taper pin for Ø35 GA and Ø32 mm tubes. VERTICAL GUARDRAIL • The vertical guardrail has a tappet at the bottom to incorporate an independent Base Support. • The tappet is connected to the main tube by means of a Ø8mm pin. • It consists of a plastic plug at its upper end. Ø48x1.8 VERT. GUARDRAIL 2000 W/CLAMP VERT. GUARDRAIL 2000 W/CLAMP (GA) VERT. GUARDRAIL 3000 W/CLAMP VERT. GUARDRAIL 3000 W/CLAMP (GA) VERT. GUARDRAIL 4000 W/CLAMP VERT. GUARDRAIL 4000 W/CLAMP (GA) BASE SUPPORT • Support vertical protectors in working position. Union of the Support and the Protector with swing pin. • It has two plates at each end as supports and a rod with rotating plate as a tightening system. Ø48x1.8 VERTICAL GUARDRAIL SUPPORT VERTICAL GUARDRAIL SUPPORT (GA) INTERMEDIARY SUPPORT • It adds an additional holding point to the vertical protector. • Union to the protector with clamp and tightening system with rod and rotating plate. Ø48x1.8

VERTICAL GUARDRAILS VERTICAL GUARDRAIL WITH SUPPORT • The supports are welded directly at the bottom of the main tube and incorporate plates at their ends. • The tightening system consists of a threaded rod in the upper support and a rotating plate with two wings. • It has a plastic plug at its upper end. Ø48x1.8 VERT. GUARDRAIL W/SUPPORT 2000 VERT. GUARDRAIL W/SUPPORT 2000 (GA) VERT. GUARDRAIL W/SUPPORT 3000 VERT. GUARDRAIL W/SUPPORT 3000 (GA) VERT. GUARDRAIL W/SUPPORT 4000 VERT. GUARDRAIL W/SUPPORT 4000 (GA) VERT. GUARDRAIL W/SUP. 2000 W/CLAMP VERT. GUARDRAIL W/SUP. 2000 W/CLAMP (GA)...

GUARDRAIL SUPPORTS All supports, mounted with a compatible GR, have been successfully tested. They comply with the dimensional and resistance requirements of EN 13374 standard, these assemblies being classifiable as class A edge protection systems. STAIRCASE CLAMP • Articulated support designed to allow edge protection systems to be attached to both staircase slabs and ramps. • Its precise telescopic regulation system is composed of a rotating crank welded to an internal threaded rod. swing tightening • The upper gripper is tiltable and consists of a housing for guardrails and a non-slip...

GUARDRAIL SUPPORTS WALL CONSOLES • Designed to establish a work surface on facades and roofs. • The pin located at the end of the upper crossbar allows the side protection to be mounted. Round tube • For its fixing to the wall, it includes a threaded rod and a nut with plate. square tube Wall console examples of use: 2 Guardrail 40 3 Extensible security guardrail 4 Security guardrail - 1000 5 Extensible plank CONV. - 2000