Façade Scaffolding

FAÇADE SCAFFOLDING DCM 49 FAÇADE SCAFFOLDING The Façade Scaffolding DCM 49 can be adapted to any type of work, from the easiest to the most difficult, owing to its strength and safety. It is versatile and easy-to-handle scaffolding, which permits multiple assemblies using few components. The DCM 49 is subject to the terms of use: ROYAL DECREE 2177/2004, of November 12 (Establishing the minimum health and safety requirements for the use of work equipment by workers in temporary elevated work). Technical specifications: Steel tube ø 48 mm. Grade St-44. All components are hot dip galvanized with...

DCM 49 INITIAL COMPONENTS The I and A-type supports enable the scaffold to be set out and facilitate the assembly of the frames. The I-type support has a 12 cm long square plate with drill holes to attach it to the ground. A-type supports are held by 2 plates, providing stability when assembling the frames. They all have a flange for a 48 mm diameter tube with a fast-attaching taper pin to secure the frame. Hot-dip galvanized with a thickness of 75 microns. A-720 TRESTLE T-FR-B Upright poles and horizontal crossbars made from Ø48 mm tube. This provides high stability thanks to its 4 points of...

FAÇADE SCAFFOLDING GUARDRAILS FIXED GUARDRAIL Made from round tubes of various diameters, these make the assembly rigid thanks to their 4 flanges with conical wedges. The extendable guardrail enables a broad range of module lengths to be achieved, with the length being fixed using flanges with wedges. Hot-dip galvanized and with a minimum thickness of 75 microns. EXTENSIBLE GUARDRAIL FIXED GUARDRAIL DCM-49 3000 Brida para ajuste de longitud HANDRAILS Made from Ø35 mm tube, they have flanges for Ø48 mm tube at both ends with a conical wedge. Hot-dip galvanized with a minimum thickness of 75 microns....

DCM 49 FIXED STEEL PLANKS The planks comply with the European Standard EN 12811. An extremely resistant, cross-perforated working surface made from shaped/folded metal and anti-slip covering. The two welded tubes facilitate to handling. Available widths: 30 / 37 cm Zinc-plated with a minimum thickness of 15 microns. Complies with the requirements of the 12810-2 fall arrest system. L 30 cm H H: edge height C: load capacity ACCESS PLANKS The planks comply with the European Standard EN 12811. Aluminium structural frame. A working area made of 12 mm thick, damp-proof and anti-slip board. Ladder supplied...

FAÇADE SCAFFOLDING TOEBOARDS Designed to complete the side protection (guardrail). Made from zinctreated sheet metal (Sendzimir). Metal clasps on both ends. Protective height of 15 cm. RUNNERS Made of Ø48 mm round tube, they allow the positioning of platforms at any height of the frames, coupling them by means of the flanges provided at both ends or by means of a bolt-type pin, in the drilled frames (E 2000 B2T). Hot dip galvanized. BRACKETS Intended to extend the work surface, it is attached to the scaffold frame by means of a Ø48 mm pipe flange. It has a 48 mm outer diameter bushing to couple...

Setting out the initial components. The I-300 supports are put into position on the inside of the scaffold, with the A-300 supports on the outside. Erect the fixed and access platforms, leaning the access ladder on the bottom crossbar of the E 2000 B2 T frame. Erect the E 2000 B4 frames at the ends and the E 2000 B2 T frames in the central sections, attached to each other with handrails. Assemble the diagonal brace on any module that needs it. Put the second level of frames in position. Assemble the side guardrail and the toeboard. Fix diagonal braces along the level and latch it to the wall....

Ctra. Santa Bárbara - La Sénia, km 4,6 Tarragona - Spain Modular Scaffold Ladder Frame Scaffold Sectional Scaffold Access Towers European Frame Scaffold Aluminium Rolling Towers Shoring Towers SHORING TOWER D Façade Scaffold Steel Rolling Towers Stages, Ramps and Grandstands Scaffold Accessories Product manufacturer: Dacame S.L. · Product design: Dacame, S.L. · Graphic design: Dacame, S.L. · Production: Dacame, S.L. The content of this catalogue is protected in its entirety by copyright. It is completely prohibited to copy the images, texts, illustrations and graphic concepts, totally or partially,...