High-Capacity Precision Balances High Capacity Taking Weighing Precision and Protection to New Heights
Open the catalog to page 1New and Improved―Precision Balances Ideal for Heavy-Duty Weighing In Tough Industrial Conditions Who else is interested in a laboratory balance that provides the feel of a washdown bench scale? The GX-L/GF-L series, the successor to A&D’s long-selling GP series, continues to allow precise weighing of heavy or large amounts of materials in demanding conditions. In addition, now as part of the A&D Apollo family, these models also offer various advanced features that make your weighing easier and more efficient, not to mention more accurate. Flexible display position Swing-arm display stand Unlike...
Open the catalog to page 2Safeguard against spillage IP65 dust and waterproof The GX-L/GF-L series, which are IP65-rated, permit no ingress of dust, and can withstand water projected from any direction, as defined by the IEC/EN standard 60529. This makes the balance highly suitable for working with liquid or powder materials, or use in dusty/wet environments, with no need to worry about damaging it. Further balance protection Impact shock detection (ISD) The weight sensor of a precision balance will be damaged if continually affected by loads with acceleration (impact shocks). This typically occurs in factories where objects...
Open the catalog to page 3Data output/communication RS-232C (D-Sub 9-pin) and USB (Mini-B) interfaces as standard The USB interface can be toggled between Quick USB mode (plug-and-play with weighing data output to a PC only) and Virtual COM mode (for bi-directional communication*2). A USB cable (1.8 m) is supplied as standard. The GX-L/GF-L series remain IP65-rated when a USB cable is connected to the USB interface. For the RS-232C interface, a 5-meter waterproof RS-232C cable is available as a separately-sold accessory (AX-KO2737-500). *2 Installation of dedicated driver software is required for Windows 8.1 or earlier....
Open the catalog to page 4Automatic precision assessment (APA) In APA mode, the balance first makes a quick diagnoses on whether there is a critical failure (Dia-Check), and then shows a repeatability test result (Standard Deviation) as well as the minimum weight (QuickMin-S) calculated using an electronically controlled load (ECL).*4 It takes less than 1.5 minutes and can be readily included in a daily check SOP. is generating a *4 ECL to A&D's patented technology of by purposely minute load (0.3 3% of the balance capacity) altering the equilibrium state of the electromagnetic force restoration sensor. Automatic minimum...
Open the catalog to page 5Tare memory The tare value can be saved in non-volatile memory. When this function is activated, the power-on zero/tare is turned off. Therefore, even if the power supply is interrupted during weigh-in or loss-in-weight measurement (e.g. filling), the net value displayed before the loss of power is restored once the balance is turned on again. Data memory Each balance has a capacity to store up to 200 weighing results + 50 sensitivity adjustment/calibration test results (all with timestamps), and 50 unit masses to be used in counting mode, 20 sets of upper/lower limit values to be used in comparator...
Open the catalog to page 6Repeatability (standard deviation) Minimum weight*ii Stabilization time (typical when set to FAST) Sensitivity drift (10 to 30 °C/50 to 86 °F, when automatic self sensitivity adjustment is OFF) Accuracy immediately after internal sensitivity Operating environment 5 to 40 °C (41 to 104 °F), 85%RH or less (no condensation) 200 weighing results + 50 sensitivity adjustment/calibration test results (with timestamps), 50 unit masses Data memory for counting mode, 20 sets of upper/lower limit values for comparator mode, and 20 tare values Display refresh rate Units of measure* Percent mode 5 times/second,...
Open the catalog to page 7Comparator relay output/buzzer/RS-232C/external key input interface Underhook for models with 62 kg capacity or above Only one of GXL-04, GXL-06, GXL-08, GXL-27, or the standard (RS-232C and USB) interfaces can be used. 10 The GX-L/GF-L series are not IP65 with GXL-04, GXL-06, or GXL-08. 11 Please contact your local A&D representative to find out whether GXL-27 is certified for compliance with Bluetooth® communication laws in your country. Remote controller Underhook for models with 42 kg capacity or below Remote display Compact printer Weighing data logger Weighing environment logger GXL-08*9*10...
Open the catalog to page 810 Pages
4 Pages
2 Pages
4 Pages
12 Pages
1 Page
1 Page
1 Page
1 Page
1 Page
2 Pages
2 Pages
2 Pages
8 Pages
2 Pages
1 Page
1 Page
1 Page
4 Pages
4 Pages
4 Pages
6 Pages
2 Pages
6 Pages
4 Pages
6 Pages
2 Pages
6 Pages
8 Pages
2 Pages
2 Pages
2 Pages
6 Pages
16 Pages
8 Pages
12 Pages
2 Pages
4 Pages
2 Pages
2 Pages
4 Pages
30 Pages
4 Pages
3 Pages