Catalogs >
Cyberbond >
Titan 8242

Titan 8242
2Pages

Catalog excerpts

TECHNICAL DATA SHEET Titan 8242 is a single component anaerobic threadlocking adhesive, which is thixotropic and develops medium strength. Titan 8242 prevents the loosening of threaded fasteners, and is suitable for applications where disassembly with hand tools is required for servicing. Titan 8242 is certified to ANSI/NSF 61 Section 6: Drinking Water System Components. Physical Properties - Monomer (Uncured) Base Compound Appearance Dimethacrylate Ester Blue liquid Thixotropic 1,200 + 400 @ 20 RPM Mil-S-46163A, Type II, Grade N; ANSI/NSF 61 Section 6 Hot Strength (%RT strength, tested at temperature) Gap Fill Specific Gravity Flash Point Shelf Life Storage Condition RoHS-Compliant Physical Properties - Polymer (Cured) Appearance Locking Strength Service Temp Range Full Cure Time Pin/Collar Strength Blue Solid Medium -65 to 300 °F 24 hours 1200 psi 8.3 N/mm2 Newton meters Breakaway Torque Prevailing Torque Setting Time / Full Cure Time* 10 15 20 20 minutes minutes minutes minutes Solvent Resistance Solvent Alcohol Ester (aromatic) Ethanol, Methanol Ketone (aromatic) Acetone, Benzophenone Benzyl, Toluol, Xylol Halogenated hydrocarbons Petrol, Heptanes, Hexane Aromatic hydrocarbons Aliphatic hydrocarbon (alkanes) Stainless Steel Heat Aging (aged at temp indicated and tested @ 22°C) Performance of Cured Adhesive Steel Brass Zinc-Plated Stainless Steel Methylenchloride, Chloroform, Chlorobenzol Weak aqueous acid Nitrite, muriatic acid, sulphuric acid, phosphoric acid Weak aqueous base sodium hydroxide solution, caustic potash

Open the catalog to page 1

General Instructions Surfaces to be bonded should be clean and dry and free of grease. Product should be applied in enough quantity to fill all engaged threads. The product performs best in thin bond gaps. Very large gaps may create gaps that will affect the cure speed and overall strength. Good contact is essential. An adequate bond develops in 15 to 45 minutes and maximum strength is attained in 24 hours. This product is not recommended for use in pure oxygen environments and/or oxygen-rich systems and should not be slected as a sealant for chlorine or other strong oxidizing materials....

Open the catalog to page 2