TECHNICAL DATA SHEET Cyberlite U334 is a high-viscosity UV-curable adhesive designed to bond well on a variety of substrates. It shows particular effectiveness on polycarbonate, glass and PET/PETG. Its high elongation and flexibility make it well-suited for applications requiring vibration or impact resistance. Physical Properties - Monomer (Uncured) Appearance Viscosity Specific Gravity Flash Point Shelf Life Storage Condition RoHS-Compliant Modified Acrylate Light Straw Liquid 2000 +/- 1000 cps 1.1 g/cc > 95°C 6 months 8°C to 21°C in darkness Yes % Strength Retained @ Given Dosage 120% Physical Properties - Polymer (Cured) Setting Time* Full Cure Time Appearance Tack-Free Surface? Elongation Shore Hardness Optimal Wavelength <3 seconds 24 hours Colorless solid Yes 400% 70 (Shore A) 420 nm 300 to % of Full Strength Retained Base Compound Performance of Cured Adhesive Substrate Metal PETG Glass PMMA PC Solvent Alcohol Ester (aromatic) Ethanol, Methanol Ketone (aromatic) Acetone, Benzophenone Aliphatic hydrocarbon Petrol, Heptanes, Hexane (alkanes) * n/r = not recommended for use on this substrate Aromatic hydrocarbons Methylenchloride, Chloroform, Chlorobenzol Nitrite, muriatic acid, sulphuric acid, phosphoric acid Weak aqueous base Weak aqueous acid Benzyl, Toluol, Xylol Halogenated hydrocarbons Performance Range, by Substrate sodium hydroxide solution, caustic potash Metal PETG Glass PMMA PC 0

General Instructions Surfaces to be bonded should be clean and dry. Dispense a drop or drops to one surface only. Apply only enough to leave a thin film layer after compression. Press parts together and expose to UV dose when ready. An adequate bond should develop rapidly, depending on UV dose efficacy, and maximum strength is attained in 24 hours. Wipe off excess adhesive from the top of the container and recap. Cyberlite products, if left uncapped or exposed to sunlight, may deteriorate or cure prematurely. For safe handling information on this product,consult the Material Safety Data Sheet...