TECHNICAL DATA SHEET Apollo Z 396 is a single component, low to medium viscosity ethyl cyanoacrylate adhesive. It is a designed as a slow-setting formulation suited specifically to rubber to metal bonding. Physical Properties - Monomer (Uncured) Base Compound Appearance Modified Ethyl Clear Specific Gravity Flash Point Shelf Life Storage Condition Physical Properties - Polymer (Cured) Full Cure Time Hot Strength (%RT strength, tested at temperature) 120% 100% Service Temp Range Time Until Full Cure (% of RT strength) seconds seconds seconds Performance of Cured Adhesive N/mm² Heat Aging (aged at temp indicated and tested @ 22°C) *Rubber figures given are typical. Your results may vary by specific rubber type. **Tested to ASTM 4501 Performance Range, by Substrate 0.0 Rubber (typical)

Solvent Resistance Example Ethanol, Methanol Ethylacetate Acetone, Benzophenone Petrol, Heptanes, Hexane Aromatic hydrocarbons Benzyl, Toluol, Xylol Halogenated hydrocarbons Methylenchloride, Chloroform, Chlorobenzol Weak aqueous acid Nitrite, muriatic acid, + + + (– – – if sulphuric acid, phosphoric concentrated) acid Solvent Alcohol Ester (aromatic) Ketone (aromatic) Aliphatic hydrocarbon (alkanes) Weak aqueous base sodium hydroxide solution, caustic potash General Instructions Surfaces to be bonded should be clean and dry. Dispense a drop or drops to one surface only. Apply only enough to...