TECHNICAL DATA SHEET Apollo H-2 is a single component, low viscosity cyanoacrylate adhesive. It is an extremely fast-setting adhesive, ideal for bonding preassembled parts, rubber and leather. Apollo H2 is designed to set and adhere rapidly to inactive surfaces. Physical Properties - Monomer (Uncured) Base Compound Appearance Ethyl Clear Specific Gravity Flash Point Shelf Life Storage Condition Physical Properties - Polymer (Cured) Full Cure Time Hot Strength (%RT strength, tested at temperature) 120% 100% Service Temp Range Time Until Full Cure (% of RT strength) seconds seconds seconds Performance of Cured Adhesive N/mm² Heat Aging (aged at temp indicated and tested @ 22°C) *Rubber figures given are typical. Your results may vary by specific rubber type. **Tested to ASTM 4501 Performance Range, by Substrate 0.0 Rubber (typical)

Solvent Resistance Example Ethanol, Methanol Ethylacetate Acetone, Benzophenone Petrol, Heptanes, Hexane Aromatic hydrocarbons Benzyl, Toluol, Xylol Halogenated hydrocarbons Methylenchloride, Chloroform, Chlorobenzol Weak aqueous acid Nitrite, muriatic acid, + + + (– – – if sulphuric acid, phosphoric concentrated) acid Solvent Alcohol Ester (aromatic) Ketone (aromatic) Aliphatic hydrocarbon (alkanes) Weak aqueous base sodium hydroxide solution, caustic potash General Instructions Surfaces to be bonded should be clean and dry. Dispense a drop or drops to one surface only. Apply only enough to...