TECHNICAL DATA SHEET Apollo 2004 is a single component low viscosity cyanoacrylate adhesive. It is a fast setting adhesive ideal for bonding all types of rubbers and preassembled parts. Apollo 2004 is approved to ISO 10993-5 for biocompatibility, making it suitable for use in medical device applications. Physical Properties - Monomer (Uncured) Base Compound 10993-5 10993-5 Mil-A-46050C, Type II Class I, A-A-3097, Type II Class 1 Specific Gravity Flash Point Shelf Life Storage Condition Physical Properties - Polymer (Cured) Full Cure Time Hot Strength (%RT strength, tested at temperature) Service Temp Range Time Until Full Cure (% of RT strength) seconds seconds seconds Performance of Cured Adhesive N/mm² Heat Aging (aged at temp indicated and tested @ 22°C) *Rubber figures given are typical. Your results may vary by specific rubber type. **Tested to ASTM 4501 Performance Range, by Substrate 0.0 Rubber (typical)

Solvent Resistance Example Ethanol, Methanol Ethylacetate Acetone, Benzophenone Petrol, Heptanes, Hexane Aromatic hydrocarbons Benzyl, Toluol, Xylol Halogenated hydrocarbons Methylenchloride, Chloroform, Chlorobenzol Weak aqueous acid Nitrite, muriatic acid, + + + (– – – if sulphuric acid, phosphoric concentrated) acid Solvent Alcohol Ester (aromatic) Ketone (aromatic) Aliphatic hydrocarbon (alkanes) Weak aqueous base sodium hydroxide solution, caustic potash General Instructions Surfaces to be bonded should be clean and dry. Dispense a drop or drops to one surface only. Apply only enough to...