Remote Sensor Control The WM-531 Shaft Hand Control is built for a range of offroad applications. The unit is designed for remote installation and mechanical interface with a throttle position sensor. It is infinitely variable between 0 and 54 degrees, with applicable uses that include engine RPM and chassis module outputs. The Remote Sensor Control unit is equipped with a Hall Effect non-contact sensor that can be programmed for analog output and/or integrated switches. The electronics are IP67 sealed and highly EMI resistant (SAE J1113). In addition, the remote sensor control unit can be customized with contact or PWM sensors. The Remote Sensor Control is environmentally protected, allowing it to be mounted inside or outside the cab. It is made out of aluminum with stainless steel shaft. The unit is available with two shaft designs: knurled and Dshaft. SPECIFICATIONS PRODUCT LIFE Full Travel Cycles Electronics IP67 sealed (IEC 60529) SAE J1113 Compliant Operating Voltage Output Signal 5V and 12V-24V Dual APS, Dual PWM, APS, PWM, APS/IVS TRAVEL ANGLE Operating Temp Range Storage Temp Range Humidity Sand/Dust Main Body Shaft Sensor Housing Aluminum, 6061 Stainless steel PBT

TYPICAL OUTPUT CHARACTERISTICS (other outputs are available) © 2015 Curtiss-Wright. All rights reserved. Specifications are subject to change without notice. All trademarks are property of their respective owners. USA Portland Oregon T: +1.503.684.8600 F: +1.503.684.3879 [email protected] www.cw-industrialgroup.com Christchurch United Kingdom T: +44.1425.271444 F: +44.1425.272655 [email protected] www.cw-industrialgroup.com Shanghai China T: +86.213.3310670 [email protected] www.cw-industrialgroup.com