Rugged Single-Axis Hall-effect Joystick  Contactless – Hall-effect technology  Single axis control with spring to center or friction hold lever action  Choice of grips including Center and End Locking  5Vdc or 9-30Vdc supply  Dual channel output with optional ramp directions  Analogue (Vdc) or Digital (PWM) outputs  Extremely low signal noise – less than 1mV rms  Operating temperature -40 to +85°C  Environmental protection up to IP69K above the panel – dependent on grip selected  Electronics sealed to IP69K  53mm under-panel depth The JC1500 joystick utilizes contactless rotary position sensor technology combined with a rugged, low profile design. The joystick provides reliable and accurate output signals - and includes a second output to enable error checking of the system integrity. The JC1500 is intended for use in the off-highway specialist vehicles market - particularly where reliability and strength are paramount e.g. Aerial Work Platforms. The JC1500 joystick complements the existing range of JC150 potentiometer track joysticks and has the same panel mounting details – allowing replacement or upgrade with no panel modifications. If a JC1500 is used to replace a JC150 joystick then due consideration needs to be taken of the supply voltage This JC1500 joystick is designed to share the same range of handles and grips as used in the JC150 and JC60

SPECIFICATIONS SUPPLY SUPPLY VOLTAGE SUPPLY CURRENT OVER VOLTAGE REVERSE POLARITY PROTECTED POWER-ON TIME 220 mm long 4 core (24 AWG) Flying lead ANALOGUE OUTPUT OUTPUT VOLTAGE (5V) OUTPUT NOISE INPUT/OUTPUT DELAY DIGITAL (PWM) OUTPUT PWM FREQUENCY 244Hz ± 20% over temperature range 10-90% over measurement range GENERAL OUTPUT DATA RESOLUTION LOAD RESISTANCE SHORT CIRCUIT PROTECTION Output to GND and output to supply in 5V mode MECHANICAL ANGLE 530g without handle fitted LEVER OPERATING FORCE (spring return to center) Maximum allowable (Spring return and friction) 110Nm on axis of movement 70Nm...