Series BND Extruded Heat Sinks ADHESIVE PEEL AND STICK HEAT SINKS Technical Data ELECTRONIC COMPONENTS Adhesive Peel and Stick Aluminum Heat Sinks • Pre-applied adhesive − just peel off the release liner and press onto the component • With pre-applied adhesive, just peel • Reducesrelease liner and press onto themessy off the assembly costs − no more adhesives or greases required component •• Reduces mechanical bond more Excellent assembly costs; no messy adhesives or greases required • Thermally optimized pin fin • Excellent mechanical bond •• Thermally optimized pin fin Omnidirectional •• Omnidirectional Adhesive shear strenght at 100ºC is 36 psi. A one inch square strength would require 36 lb. of • Adhesive shear heat sinkat 100°C is H±0.015 36psi (a one inch square heat force to remove heat sink. sink would require a 36lb. force to remove heat sink) • Applicable for BGA, PGA, PLCC, and QFP • Applicable for BGA, PGA, PLCC, packages HEAT SINK SPECIFICATIONS SIZE HEAT SINK PART NUMBER*** *Thermal resistance of adhesive tape is included. **Thermal resistance values based on power density of 3 watts/in.2 ***Part numbers listed for standard black anodized heat sinks with CTS adhesive tapes. THERMAL RESISTANCE CASE TO AMBIENT* °C/WATTS FORCED NATURAL CONVECTION CONVECTION** @ 400 LFPM

Series BDN Forged Heat Sinks Dimensional Information: CLIP STYLES MATERIAL: Nylon Plastic per UL94-V0 0.9mm +/- 0.3mm Short Height Color: Orange 1.7mm +/- 0.3mm Medium Height Color: Blue 3.3mm+/- 0.3mm Tall Height Color: Yellow Part Number Clip Size Length x Width x Height (mm) Case Height Adhesive Tape Information: TAPE STYLES Dielectric Strength (V/mil) Double-sided acrylic adhesive on a Kapton® MT carrier Double-sided acrylic adhesive loaded with aluminum oxide on an aluminum foil carrier Double-sided silicone adhesive with expanded aluminum mesh carrier Doubled-sided acrylic adhesive loaded...