Model LV-1 and XV-1 Micro Sandblasters The SWAM-BLAST® Micro Sandblasters introduce a precise amount of finely graded abrasive powder into a controlled stream of compressed air through the abrasive/air pathway and out a manually or automatically positioned nozzle tip. The Model LV-1 (Large Volume) is best for operating in production lines and in the SWAM® Automated Systems. The LV-1 features independently adjustable powder flow control and air pressure regulation for total process control, an hour meter for SPC monitoring and a leak detection system for the pinch valve assemblies. It holds approximately 20 pounds of aluminum oxide and has a separate mixing powder tank for a consistent powder feed rate from a full tank to an empty tank. For applications where the Model LV-1 is not enough, the Model XV-1 (Xstream™ Volume) is the solution for the heaviest output requirements. Similar to the LV-1, it is equipped with larger hoses and fittings throughout the abrasive/air pathway. The Model LV-1 works very well with a nozzle range from .018” up to .060”. For the Model XV-1, the optimum nozzle range is .032” up to .090”. CRYSTAL MARK, INC. offers additional options for both models such as a Low Powder Sensor to detect low levels of abrasive powder within the auxiliary tank and a Pulse Shaker that enhances the powder flow from the auxiliary tank to the mixing tank. Also available are work chambers, dust collectors and air dryers in various configurations to meet your specific requirements. CRYSTAL A1ARK, INC. A SWAN TECHNOLOGIES CORPORATION 613 Justin Avenue Glendale, California 91201-2396 (818)240-7520 • (800)659-7926 • FAX (818)247-3574 www.crystalmarkinc.com • [email protected] ©2008 Crystal Mark, Inc. ALL RIGHTS RESERVED. SWAM and SWAM BLAST are registered trademarks of Crystal Mark, Inc. LV-1 XV-1_2008