Catalogs >
Crystal Engineering >
m1M Manual

m1M Manual
4Pages

Catalog excerpts

Quick Reference ills Bug • Tare ft-lbs mSHg mmH20 TEST & CALIBRATION INSTRUMENTS

m1M Quick Reference Note: Pressing the enter button always returns the gauge to operating mode. If you want to set multiple Display Functions, press the setup button to navigate from one Display Function to the next, then press the enter button when you are done. Gauge Setup Basics 2 View Setup options Gauge Setup Map Maximum, Minimum, or Averaging (Averaging window: 2 to 20 samples) t: 68F t: 60F All units are not available with every pressure range. * H20 icons and temperature settings will only display on H20 enabled units.

Open the catalog to page 2

Gauge Setup Map continued Backlight Timer 3x Power Management *This menu can be accessed only when the gauge is off. Lt: 15 (light stays on for 15 seconds) Lt: 60 (light stays on for 60 seconds) Lt: On (light does not turn off automatically) To Clear Peaks or Line Pressure Ultra Low Power Mode rd 0.1. . . . . . . (1/10 minutes . . . 30,000 hours) rd 0.2. . . . . . . (1/5 minutes . . . . 25,000 hours) setup Troubleshooting Err 1 displayed: The m1M checks the internal calibration every time it’s turned on. Contact factory for further instructions. Err 2 displayed: The m1M has tried to display...

Open the catalog to page 3

Open the catalog to page 4

m1M Manual 4Pages

Catalog excerpts

All Crystal Engineering catalogs and technical brochures

m1M Manual
4Pages