24 VDC Power Supply Manual
7Pages

{{requestButtons}}

Catalog excerpts

24 VDC Power Supply Manual - 1

24VDC Loop Operation Manua Power Supply

Open the catalog to page 1
24 VDC Power Supply Manual - 2

24VDC Loop Power Supply Operation Manual   1 INTRODUCTION The 24VDC Loop Power Supply (24VDCPS) is a portable, battery-powered, loop power supply and is ideal for sites where power is unavailable. The low noise regulated output is suitable for use with smart transmitters. Power is automatically turned off when load is removed, preserving battery life. Outputs feature short circuit protection. Three LEDs indicate power, low battery, and fault status. A protective boot and two AA batteries are included. QUICKSTART/OPERATION DIAGRAM Output Terminals: 24 VDC output. Observe correct polarity. On...

Open the catalog to page 2
24 VDC Power Supply Manual - 3

24VDC Loop Power Supply Operation Manual   2 BATTERIES The 24VDCPS uses 2 AA batteries. Recommended batteries are Lithium (non-rechargeable), Alkaline, or NiMH (rechargeable). To avoid damage by over-dis- charging, rechargeable batteries should be removed when the Low Battery LED () illuminates. Non-Rechargeable batteries may continue to be used until the Red Fault LED () illuminates, at which time the output voltage will have fallen below 24 V. Lithium batteries are recommended for best performance in cold weather operations. Typical Battery Life (Conditions: 12 mA loop current, 23° C)...

Open the catalog to page 3
24 VDC Power Supply Manual - 4

24VDC Loop Power Supply Operation Manual   3 ELECTRICAL SPECIFICATIONS Output Voltage 24 VDC +/- 2% Output Voltage Ripple < 14 mV rms Load Regulation 1% Rated Output Current 25 mA Short Circuit Protection Continuous Connections 4mm banana jacks Operating Temperature -20 to 50°C (-4 to 122°F) Storage Temperature -40 to 75°C (-40 to 167°F) Operating Humidity 95% Relative, non-condensing Power Supply 2 x AA batteries (alkaline 1.5 V included) MECHANICAL SPECIFICATIONS Overall Dimensions 4.8" x 3.1" x 1.2" Weight 200 g (0.44 lbs) including alkaline batteries ENCLOSURE Rating IP40 Housing ABS...

Open the catalog to page 4
24 VDC Power Supply Manual - 5

24VDC Loop Power Supply Operation Manual   4 DECLARATION OF CONFORMITY According to ISO/IEC 17050-1:2010 Manufacturer’s Name: Crystal Engineering Corporation An AMETEK Inc. company Manufacturer’s Address: 708 Fiero Lane, Suite 9 San Luis Obispo, CA 93401 USA Declares under sole responsibility that the product as originally delivered Product Name: Model Number: 24VDC Loop Power Supply Series 24VDCPS Complies with the essential requirements of the following applicable European Directives, and carries the CE marking accordingly: EMC Directive 2004/108/EC Standard EN 55011:2007 EHSR EN...

Open the catalog to page 5
24 VDC Power Supply Manual - 6

24VDC Loop Power Supply Operation Manual   5 CONTACT US Phone (805) 595-5477 Toll-Free (800) 444‑1850 Fax (805) 595-5466 Email crystal@ametek.com Web crystalengineering.net TRADEMARKS This manual contains the following third-party trademarks, both registered and unregistered. All marks are the property of their respective companies. Rayovac® and Maximum Plus™ . . . . . . . . . . . . . . . . . Rayovac Corporation Duracell®. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Duracell Inc. Corporation Energizer® and Eveready. . . . . . . . . . . . . . . . . . . . . . ....

Open the catalog to page 6
24 VDC Power Supply Manual - 7

© 2014 Crystal Engineering Corporation 708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701 TEST & CALIBRATION INSTRUMENTS

Open the catalog to page 7

All Ametek Calibration catalogs and technical brochures

  1. PTC series

    14 Pages

  2. RTC series

    15 Pages

  3. PK II

    3 Pages

  4. ATMi

    7 Pages

  5. HPC50

    6 Pages

  6. CrystalCalHP

    7 Pages

  7. m1M Manual

    4 Pages

  8. 30 Series

    4 Pages

  9. FastCalXP

    9 Pages