Morse LNC Series Delrin† Chain Couplings • No Lubrication No dirt catching problems with grease. • Corrosion Resistant Where corrosion is a problem Delrin Couplings are a must. Runs quieter than metal couplings. • Pollution-Free Couplings A neat way to keep things clean. Smooth outer surface of Delrin Chain. Cost less to install and maintain. Morse Delrin† Chain Couplings for Applications up to 5000 RPM and from Fractional to 45kW • For the safety feature of the smooth outer surface without a cover. • For food processing, textile and other machinery • For centrifugal pumps and steady load applications. which avoids the use of oil or grease. Available with minimum plain bore, finished bore with standard keyway and setscrew, or TL taper bore. kW Power Ratings LNC 400 Series 1/2 inch Delrin† Chain N400 Series 1 /2 ” pitch .2 through 21kW Available from stock with minimum plain bore, TL taper bore or bored to suit. kW Power Ratings LNC 600 Series 3/4 inch Delrin† Chain N600 Series 3 /4 ” pitch 1.1 through 45kW Available from stock with minimum plain bore, TL taper bore or bored to suit. All Delrin Couplings operated below 100 rpm must not be subjected to torque values in excess to those shown in tables above. Refer to page 2 for service factor and selection procedure. †DuPont Registered Trademark. Email: [email protected] • Where corrosion is normally a problem from atmospheric conditions.

Morse LNC Series Delrin† Chain Couplings LNC 400 Series Dimensions - Plain Bore Couplings Coupling No. • Temperature range from –30˚C to +66˚C • Parallel misalignment of 0.12 mm • Total end float of 1.5mm Dimensions - Taper Lock Couplings Coupling No. Bush Size Dimensions - Plain Bore Couplings Coupling No. Dimensions - Taper Lock Couplings Coupling No. A slip-fit coupler pin which provides ease of assembly or dis-assembly can be supplied with all couplings Email: [email protected] • Temperature range from –30˚C to +66˚C Bush Size *Hub recessed for chain clearance. †DuPont Registered Trademark....