GNM Cartridge Filters Nylon 6,6 Membrane Applications Process Water Inks & Dyes Integrity Test Information Representative samples from each lot are tested for integrity to ensure consistent performance. Maximum Operating Parameters Differential Pressure • Forward Operating Temperature Recommended Changeout Pressure 82 °C (180 °F) at 10 psid (0.69 bard) in water 35 psid (2.4 bard) General Service Grade Nylon 6,6 Membrane Filter Cartridges are designed for general purpose use wherever a pleated membrane filter is required. Designed to hold the maximum amount of filter media that can be completely and effectively utilized in a cartridge, GNM filters lower the cost of filtration. GNM cartridges are flushed with 17+ megohm-cm water to remove potential extraneous manufacturing debris. These cartridge modules are also individually tested for integrity. Construction Materials Chemical Sanitization Media Support Center Core Outer Support Cage Sealing Method Thermal Bonding Buna, Viton® (or FKM), EP, Silicone, FEP Encapsulated Silicone, FEP Encapsulated Viton (or FKM) Dimensions Length Outside Diameter Filtration Area 90 °C (194 °F), 30 minutes, multiple cycles, max 3 psid forward flow In-line Steam For all elevated temperature procedures above, a stainless steel support ring is required. Nylon does not tolerate aggressive chemical sanitization protocols. Nylon membrane cartridges are best sanitized with 1% hydrogen peroxide or 1% hydrogen peroxide and peracetic acid. Various manufacturers use different concentrations of active ingredients. Refer and adhere to the manufacturer’s instructions for sanitizing nylon membrane. Total Performance Critical Process Filtration, Inc. is a vertically integrated manufacturer of filtration products to industries in which filtration is considered a critical part of the manufacturing process. We supply a complete line of products and services to help you cost effectively satisfy all your filtration requirements from a single source. General Service Grade Filtration Media

All Critical Process Filtration filters are designed to meet the FDA requirements for processing food and beverage products. The materials used to construct GNM filters are listed by the FDA as appropriate for use in articles intended for repeated food contact as specified in Title 21 CFR sections 174.5, 177.1500, 177.1520, 177.1630, 177.2440 and 177.2600 as appropriate. Membrane filters comply with Title 21 CFR sections 210.3 (b)(6) and 211.72, for nonfiber releasing filters. All materials used to make the filters are listed in European Commission Regulation EU/10/2011, Annex 1. Quality Assurance...