Static Sieves and Filters

Static Sieves and Filters Coutex static sieves and filters are used when the cross-section of the residue to be collected is between 0.25 and 10 mm. The filters are used for rain water and the static sieves for waste water. - Irrigation water pumping stations. - Cooling water networks (steam condensers, - Water for auxiliary services (fire, health-care, etc.). - Treatment of water from manufacturing proc esses (steel, cement, ceramics, etc.). - Water treatment plants. Coutex sieves and filters are designed and manufactured to be long-lasting and low-main- tenance. They are both reliable and easy-to-use...

Longitudinal chain sieve for waste water cleaned by means of brushes and rear discharge. Impact- resistant stainless steel mesh guarantees its longevity and minimal maintenance. Lower head loss than most other sieves on the market with the same useful width. Discharge and water levels according to requirements, and canal widths from 500 to 2000 mm. Useful • Motorised equipment - Hollow shaft gear motor mounted on a floating motorised shaft. Three-phase asynchronous electric motor with IP-55 protection. • Frame (Single-section layout) - Made of AISI-304 stainless steel sheets and - Collection...

Chain Sieve. TC Gear motor AISI-304 Sieve mesh Discharge height Direction of flow 160 75 º Canal height AISI-304 Frame 490 Useful width Canal width

This is an automatic cleaning sieve that uses a brush located at the end of a revolving arm. It is forward cleaning. It allows for maximum flow rates from 38 l/s up to 750 l/s. Ideal for shallow canals. • Motorised equipment - Gear motor mounted on an oscillating base and transmission by means of chains to the motor- ised shaft. Three-phase asynchronous electric motor with IP-55 protection. - Made of rolled steel sections. Single-section layout to facilitate on-site - Made from a curved perforated steel sheet to fit the radius of the sieve. It is made of Al SI-304 stainless steel. The diameter...

Rotating Drum Filter. This is a rotating drum type filter that uses filtering panels and is cleaned by means of pres- surised water. It is ideal for situations where there is little change in the water level. Its filtering meshes vary in size from 10 mm to 0.25 mm. It is used for water that does not contain high residue levels. • Motorised equipment - Transmission is achieved by means of a steel pinion, cut into the output shaft of the gear motor, which engages with the cast iron crown wheel (built in sections for easy replacement) attached to one of the wheels of the frame. - Parallel shaft...

Rotating Drum Filter. FTR Cleaning water Motor group Filtering material Seal Direction of flow Collection chute Material support frame

Rotating Chain Filter. This is a development based on the rotating drum filter. Sieving is achieved by means of filtering panels and cleaning is achieved using pressu- rised water. It is ideal for situations where there is a large flow and in which there are significant changes in the level. Its filtering meshes vary in size from 0.25 mm to 10 mm. It is used for water that does not contain high residue levels. • Motorised equipment - The sieve is driven by a motor reducer which, by means of a double chain transmission with gear rings, turns the filter wheels. - Parallel shaft gear reducer, equipped...

Rotating Chain Filter. FCR Motor group Cleaning water Collection chute Seal Filtering material Direction of flow Material support frame