EICP Series SHEET Compact Ethernet Switch — Industrial Temperature The EICP Series offers a compact rugged 10/100 Mbps Ethernet switch with a choice of eight copper ports or a mix of six copper and two fibre ports. The units are extremely compact and intended for use where indoor temperatures are expected. Fibre optic distances up to 15 km are possible with the single-mode option. Each unit can be powered from a low-voltage AC or DC source. Features • Choose all 10/100 Mbps copper ports or add two fibre ports • Single-mode fibre distances up to 15 km • Industrial temperature range: 0°C to +60°C • 10–36 VDC or 8–24 VAC powered • LEDs for link/activity, data rate and power • UL and C-UL listed, CE Mark, RoHS compliant CTRLink CONTROLS

Data Sheet — EICP Series Product Overview The EICP Series provides standard plug-and-play features such as auto-negotiation and Auto-MDIX — allowing for quick and simple installation. However, these features plus full-duplex can be individually set for each copper port. Three models offer two fibre ports. You can choose single-mode transceivers with SC connectors (providing 15 km cable distance) or multimode transceivers with either SC or ST connectors. The copper ports can auto-negotiate 10 Mbps, 100 Mbps, half- or full-duplex. With Auto-MDIX, either straight-through or crossover cables may...

Specifications Power Requirements Operating Temperature Storage Temperature Relative Humidity Protection Mounting Shipping Weight Ethernet Communications 10-36 VDC, 6 W or 8-24 VAC, 10 VA, 47-63 Hz (see last page for details) 0°C to 60°C -40°C to 85°C 10-95%, non-condensing IP30 TS-35 DIN-rail or panel mount 1 lb (0.45 kg) IEEE 802.3 10/100 Mbps data rate 10BASE-T, 100BASE-TX physical layer, 100 m (max) CAT5 cable length 100BASE-FX physical layer, 15 km (max) single-mode [2 km (max) multimode] fibre optic cable length Regulatory Compliance Power Green = power OK Link Yellow = 10 Mbps Green...

Data Sheet — EICP Series AC Powered with Grounded Secondary The EICP Series incorporates a full-wave rectifier requiring an 8-24 VAC input from a dedicated transformer whose secondary is not grounded. Power requirements are 10 VA maximum. Sharing the same power source with other devices is not recommended. The unit can also be powered through a half-wave rectifier which allows the sharing of the same transformer with other half-wave devices. In this case, the transformer secondary is referenced to the unit’s 0 Vdc pin and could be grounded as well. For half-wave operation, the AC input should...