Data Sheet CANPCI Series CAN Module for PCI Compatible Computers • CAN 2.0B protocol compatibility • Supports both 11-bit and 29-bit identifiers • Interfaces with both CANopen and DeviceNet layers • 5 V or 3.3 V bus operation • Data rates up to 1 Mbps • Drivers are available for Windows® 98/ME/2000/XP • 16 MHz clock frequency • CE Mark • RoHS • Interfaces CAN with PCI bus • Uses the Philips SJA1000 controller chip • Compatible PCA82C200 mode • 64-byte FIFO receive buffer PRODUCT OVERVIEW Controller Area Network (CAN) is applied as an embedded communication system for intelligent devices in factories, medical equipment and even as an internal bus. So transmitting high-speed CAN data into a desktop PC is sometimes necessary for programmers, project engineers and diagnostic technicians. The CANPCI adapter, both cost-effective and versatile, is designed for either 5 V or 3.3 V bus operation for PCI compatible computers. The CANPCI adapter supports 8-bit transfers and takes advantage of the high-speed PCI bus for high data transfer speed. This design is based on the ever-popular Philips SJA1000 CAN stand-alone controller chip, which is employed in both automotive and industrial applications. The SJA1000 affords more benefits than its predecessor, the 82C200. It can operate in the BasicCAN mode — or PeliCAN mode, which supports the CAN 2.0B specification with 29-bit identifiers. The SJA1000 operates from a 16 MHz clock and features a larger receive buffer and better acceptance-filtering. Data rates are possible up to 1 Mbps. The PeliCAN mode is equipped with various features: error counters with read/write access; programmable error warning limit; last error code register; error interrupt for each CAN-bus error; arbitration lost interrupt with detailed bit position; single-shot transmission (no retransmission); listen-only mode (no acknowledge, no active error flags); acceptance-filter extension (4-byte mask); and reception of “own” messages (self-reception request). The CANPCI is available in two models: the CANPCI-DN incorporates the DeviceNet physical layer, whereas the CANPCI-CO provides a CANopen physical layer. Optically-isolated transceivers offer reverse-voltage and short-circuit protection for both the CANPCI-DN (implementing the DeviceNet 5-position, open-style connector) and the CANPCI-CO (implementing the CA

CANPCI Series Operating temperature Storage temperature Power requirements Data rate DB-9 male connector is provided with the CANPCI-CO and 5-position, open-style male connector with screw terminals is provided with the CANPCI-DN Shipping weight Regulatory Compliance CE Mark; CFR 47, Part 15 Class A Electromagnetic Compatibility Standard Test Method Description Test Levels EN 55024 EN 61000-4-2 Electrostatic Discharge 6 kV Contact EN 55024 EN 61 000-4-4 Fast Transient Burst 1 kV Clamp & 2 kV Direct EN 55024 EN 61 000-4-5 Voltage Surge 1 kV L-L & 2 kV L-Earth EN 55024 EN 61000-4-6 Conducted Immunity...

Data Sheet CANPCI Series Connector Diagrams CANPCI-CO CANPCI-DN Ordering Information Model Description CANPCI-CO CANPCI CANopen Module CANPCI-DN CANPCI DeviceNet Module Contemporary Controls, ARC Control, ARC DETECT, EXTEND-A-BUS and CTRLink are registered trademarks or trademarks of Contemporary Control Systems, Inc. Specifications are subject to change without notice. Other product names may be trademarks or registered trademarks of their respective companies. © Copyright 2007 Contemporary Control Systems, Inc. Contemporary Control Systems, Inc. Downers Grove, Illinois 60515 USA