SHEET 5-Port Skorpion Gigabit Switch Cost Effective, High-speed — Compact Size The EISK5-GT Skorpion Gigabit Switch is a five-port unmanaged Ethernet switch that provides Gigabit Ethernet (GigE) performance on all ports in order to accommodate high-speed devices such as IP cameras and modern workstations. In addition, GigE jumbo frames up to 9216 bytes are supported for the highest possible system performance. For 10/100 Mbps legacy devices, the switch will automatically reduce its port-speed accordingly, thereby accommodating the needs of just about any Ethernet automation system. This low-cost compact unit utilizes a rugged metal enclosure and is intended for installation in control panels using DIN-rail mounting. This is a plug-and-play Ethernet switch requiring no configuration. All ports automatically configure their data rate and duplex using the Auto-negotiation protocol. Depending on the capability of the link partner, communication is set at 10, 100 or 1000 Mbps and at either half- or full-duplex. Each port will accommodate either a straight-through or crossover cable by using the Auto-MDIX protocol. The unit is powered from a choice of low-voltages (AC or DC). Redundant power connections are provided for back-up power schemes. LED indicators assist in troubleshooting network issues. Plug-and-Play operation DIN-rail mounting Rugged metal enclosure Diagnostic LEDs Auto-negotiation of speed and duplex Auto-MDIX supports cable inversion UL 508 listed, c-UL listed, CE mark

Overview The Skorpion Gigabit Switch is intended for control panel installations where DIN-rail space is at a premium by requiring a width of only one inch (26 mm) of rail space. A metal DIN-rail clip attached to the aluminium enclosure can survive the toughest installation. A writable side label allows the installer an opportunity to document field cabling locations right on the unit. The switch can be powered from either a 10–36 VDC or 24 VAC (±10%) source. Its half-wave rectified low-voltage power supply allows the sharing of power with other 24 VAC/VDC control devices from a common power...

Specifications Power Requirements Operating Temperature Storage Temperature Relative Humidity Shipping Weight Ethernet Communications IEEE 802.3 10/100/1000 Mbps data rate using RJ-45 connectors, 100 m (max) Supports jumbo frames up to 9216 bytes Power “H” LEDs “L” LEDs “H” or “L” LEDs Regulatory Compliance Green = power OK Green = 1000 Mbps communication established Yellow = 100 Mbps communication established Yellow = 10 Mbps communication established Flashing = data transmissions occurring CE Mark; CFR 47, Part 15 Class A; RoHS; UL 508 Industrial Control Equipment Mechanical Drawing

Power Considerations Applied voltage must be 10-36 VDC or 24 VAC ±10% and deliver a current commensurate with power consumption. The recommended size for solid power conductors is 16-20 AWG; and for stranded conductors use 16-18 AWG. Zero volts (COM) is isolated from chassis (earth). Input connections are reverse-polarity protected. Connecting chassis to earth or using a backup source is always optional. All options shown are for use in Class 2 circuits if applied voltage is limited to 30V DC, AC Powered with AC Powered with Redundant DC Grounded Secondary DC Backup Powered Typical Switch Installation...