SC200 Series Premium, Field Configurable Vibration & Temperature Signal Conditioners Product Features Signal Conditioners Identify Transient Faults and Guard Against Failure Between Monitoring Cycles. Easily removable plugs with key alignment, avoids miswiring Now vibration data can be monitored by control room personnel, without any knowledge of vibration signals. The SC200 Series units provide process control signals to a PLC, DCS, or SCADA system, in 4-20 mA outputs, along with a selectable 0-5 VDC or 0-10 VDC signals, that are proportional to the vibration levels set within the signal conditioner. The SC200 Series also provides dynamic data to be collected for analysis with conventional Vibration Data Acquisition systems. Internal DIP switches allow easy “field configuration 2nd set” for input signal, scale values, filtering options and outputs Accepts a variety of signal inputs; acceleration, velocity, temperature and displacement (see below) Sensor Power On/Off option allows dual banding, ranges, units, filters and outputs with multiple signal conditioners to be configured for dual banding Signal Conditioners & Enclosures Specifications 4-20 mA output signal for vibration and temperature (0-1.2 VDC input) Each 4-20 mA output requires isolated common (not shared) Additional 0-5 or 0-10 VDC output signal for vibration signal input Buffered output via BNC jack and screw terminals Humidity range of 0-95% relative, non-condensing +3dB Filter Range Screw terminal connectors, detachable 35 mm DIN rail mountable Operating temperature range: -40ºF (-40ºC) to 158º F (70ºC) Electrical Input power: 24 to 32 VDC unregulated / 225 mA maximum Power from conditioner to sensor: 24 VDC, 4 mA DC sensor excitation, selectable On/Off sensor power (as required) Maximum load resistance of 600 ohms Isolation: 1000 VDC When Selecting 2 Hz or 5 Hz High Pass Filters, it is Recommended to use Piezo Velocity Sensors Cooling is required if enclosure temperature exceeds 140°F (60°C). The Part Number Listed Above is a: STOCK PRODUCT (SC203-100A-002IR-010-01K-05) - Full Scale Range Value Input Source configured per part number *All SC200 series systems are user configurable after initial set up. Not all configuration options are compatible. Please consult the factory for options, or our part configurator at: www.ctconline.com Full Scale Units I = IPS M = mm/s G = g’s D = mils - High Pass Filter Voltage Output Power Supplies 10 = 0-10 V Note: If left (in addition to standard 4-20 mA) blank, the unit provides power to sensor. 200D = 200 mV/mil Displacement Probe All Configurations Above are: Built To Order Example Part Numbers: SC207-100A-010MR-005-050-10 * Not All Configuration Options Are Compatible. Please Consult the Factory for Options, or Our Part Configurator at www.ctconline.com Lifetime Warranty on Materials & Workmanship