MH127 Series Kits Supplied Magnets MH103-1B Cap Cover Component Specifications Magnets Pull Strength Mounting Stud/Hole Dimensions (Height x Diam.) Magnet Systems- O Robust stainless steel case magnets make these units ideal for high volume route measurements. O The use of a mounting target will enhance the accuracy of high frequency data, ensure consistent measurement locations, and repeatable trending data. O The mounting target is supplied with a tapped hole, to allow the opportunity for permanently mounting an accelerometer, should it become necessary. O Protective cap covers are supplied to keep paint and unwanted debris away from the magnet target. Mounting Pad/Magnet Target Material Dimensions (Height x Diam.) Tapped Hole 1/4-28 Top Surface Flatness Bottom Mounting Surface 17-4 SS .380” x 1.00” OD (9,65 mm x 25,40 mm) .0005” (0,0127 mm) Abraded to accept adhesive Adhesive Temperature Range (Devcon Plastic Welder) Components Set Up Time Full Cure -60° to 250°F (-51° to 121°C) 2 Part Epoxy with Dispenser 4-6 Minutes 24 Hours Ordering Information for Kits Backed by our Unconditional Lifetime Warranty Page 259