*mydirectindustry

Pressure switch MDR 2

Product catalog summary

Overview: The document provides detailed specifications, technical data, and accessory options for the MDR 2 pressure switch, a high-performance device used in various industrial applications.

Specifications:

Pressure Range: 1.5 - 12 bar depending on the model.
Material: Die-cast aluminum flange.
Weight: Ranges from 300g to 320g.
Rated Insulation Voltage: 500 V.
Motor Switching Capacity: 2.2 kW at 240 V (AC 3).
Electrical Life: Over 100,000 cycles.
Mechanical Life: Over 500,000 cycles.
Max Electrical Cycles: 120 cycles/hour.
Max Mechanical Cycles: 600 cycles/hour.
Rated Operational Current: 16 A at 240 V AC 3.
Bursting Strength: Greater than 35 bar.
Permissible Medium Temperature: Air (-5 to +80°C), Water (+80°C).
Protection Degree: IP 44 according to EN 60529.

Accessories:

Unloader Valves: Various models available for different tube connections.
Cable Glands: Options with strain relief and cable support.
Cover Options: With or without On/Off lever.
Hourmeter Kit: Monitors pump and compressor running time, available for 230 V, can be mounted in four positions.

Recommendations: For retrofitting, unloader valves and cable glands are available. The hourmeter kit is recommended for monitoring operational time effectively.

Catalog excerpts

Single phase Switching capacity 2.2 kW Max. cut-out pressure 12 bar 2-pole (N.C.) Acc. to EN 60947 Flange = die-cast aluminium diaphragm media resistance MDR 2 A detailed overview of diaphragm media resistance for all pressure switches can be found on page 22. Please read the information carefully. dimensions / Circuit diagrams MDR 2 www.condor-cpc.com

Open the catalog to page 1

Pressure switch MDR 2 Accessories MDR 2 *only for pneumatic tubes with outside tolerances according to e. g. Festo PAN 6x1mm Unloader valves / Delayed unloader valves

Open the catalog to page 2

Pressure switch MDR 2 Accessories Hourmeter kit MDR 2 Description The MDR 2 can be equipped or retrofitted with an operating hourmeter to monitor the pump and compressor running time. The kit consists of an operating hourmeter for either 230 V supplied and a perforated MDR 2 cover with or without ON/OFF lever. Order reference Packing (units) High performance Pressure switches The hourmeter is available as a kit and can be attached to the cover in 4 different positions, each offset at an angle of 90°. This ensures optimum readability. can be used at 60 Hz with higher engine speed Pressure Diagrams...

Open the catalog to page 3

Pressure switch MDR 2

Pressure switch MDR 2

Catalog excerpts

All Condor Pressure Control GmbH catalogs and technical brochures