MSBHI SERIES WATER SPRAY TANKS HIGH-INTENSITY SPRAY FOR MORE RAPID COOLING MSBHI Series Cooling Tanks produce a high-pressure spray that cools tube and profile extrusions faster and in less space than immersion tanks. For pipe and tube of sufficient mass, immersion tanks compromise cooling efficiency due to the formation of an insulation layer over the hot product surface. MSBHI high intensity spray bars eliminate this problem and increase cooling efficiency through the process of extreme turbulent cooling. Cooling water droplets striking the hot surface rapidly conduct the heat away and are driven off in a continuous process. KEYHOLE DESIGN: MINIMIZES PLUMBING/ENHANCES FLOW The keyhole design of the MSBHI incorporates the spray and reservoir tanks into one compartment. The combined tanks require less plumbing, minimize future maintenance, and improve water flow through the tank for more efficient cooling of extruded products. All standard MSBHI models include an integral reservoir/spray tank, individual control of all spray zones, a spray system sized for up to 100 gpm {379 liters/min}, stainless steel lids and adjustable tank height and sideto-side movement. For faster cooling rates, you can increase the flow rate to as much as 340 gpm {1287 liters/min} and cooling efficiency with an optional process pump and heat exchanger. Other options include motorized tank forward, reverse movement and clear lids. Easy to operate Built-in water manifold system has water valves dedicated to each chamber. Individual spray bars control the direction of the spray to optimize cooling. Quick dump valves are provided for draining the tank. Stainless-steel components The tank, water reservoirs, and drip trays are stainless steel. Other surfaces are painted for corrosion resistance. Tank lengths of 16 to 24 feet The MSBHI is available in a range of sizes; from a 16-foot {4.9 meters}, twochamber tank to the 24-foot {7.3 meters}, three-chamber tank. Options to fit your needs Optional recirculation and heat exchanger packages increase cooling efficiency by circulating from 100 to 340 gallons {379 to 1287 liters} of cold water per minute around the extrudate. Reduce maintenance with a filter system for optional 5, 7.5 or 15 Hp process pumps. Also available: Four foot start-up chamber for flood or independent vacuum and recirculation system, motorized forward and reverse tank movement and nozzle spray bar configuration.

MSBHI SERIES WATER SPRAY TANKS C MODEL TANK STYLE Performance characteristics Tube/profile capacity inches {mm} Number of compartments Length of compartments ft {cm} OPTIONS Increase cooling rates with a process pump and heat exchanger: 5 Hp pump (100 gpm); 7.5 Hp (180 gpm); and 15 Hp (340 gpm). Process filter system for a 5 Hp, 7.5 Hp or 15 Hp pump. Motorized forward and reverse tank movement. Roller system for composite products. Vacuum system for pipe and hollow profiles. SPECIFICATION NOTES: * Centerline height is adjustable - 2 or + 3 inches {-50.8 or +76.2 mm}. † Amp draws will increase...