Part Number : ORD228S-1 Reed Switch - Moulded/SMD - Normally Open Contact Product Data Sheet PICTURE DIMENSIONS                 Drawings not to scale. All dimensions in mm [inches] nominal. SPECIFICATIONS Contact Form Contact Material Contact Rating Switching Voltage Switching Current Carrying Current Breakdown Voltage Contact Resistance Insulation Resistance Pull - In Sensitivity Drop - Out Sensitivity Operate Time Bounce Time Release Time Operating Frequency Resonant Frequency Vibration Shock Capacitance Operating Temperature Range Test Coil ORDERING INFORMATION PART NUMBER ORD228S-1 10 50 Type Minimum Sensitivity (AT) Maximum Sensitivity (AT) Example: Type ORD228S-1 Standard Sensitivity. Pull-in sensitivity between 10 - 50 AT is PART NO: ORD228S-1 10 50. When cutting or bending switch leads it is important that the glass seal is not damaged. The cutting or bending point should be no closer than 3mm (.118in.) to the glass to metal seal and the lead should be supported between the cutting or bending point and the glass to metal seal. We offer a crop and form service for Reed Switches to be customized to your specification. REVISION NOTE Drawing dimensions were updated TAKE A LOOK AT OUR VARIETY OF PRODUCTS Float Switches Acceleration / Shock Switches Movement Sensors Reed Relays Solid State Relays High Breakdown Switches Reed Switches Electronic Tilt / Tip Over Low Cost - Non Rubber Keymats Mercury Switches Silicone Rubber As part of the company policy of continued product improvement, specifications may change without notice. Our sales office will be pleased to help you with the latest information on this product range and the details of our full design and manufacturing service. All products are supplied to our standard conditions of sale unless otherwise agreed in writing. © 2010 Copyright Comus International, Inc. Website: www.comus-intl.com Publisher