Compur Statox 501 Control Module
2Pages

Compur Statox 501 Control Module Compur Statox 501 Control Module – One for all The Statox 501 control module works with all types of sensor heads. No matter which sensing technology is used in the field, the Statox 501 control module can always process the signal. One control module together with a sensor head forms a complete gas detection system. Everything on board Great in performance, modest in requirements: Statox 501 is small in size and energy efficient. It is DIN rail – mounted, so there is no need for a rack. It needs only 5 W at 24 V DC. It has three powerful relays, of which each can handle 2 A, as well as an analog 4 – 20 mA output to be connected to a recording device or process control system. Each control module provides a half bridge, display unit, relay station, and calibration interface for catalytic and infrared sensors. It is also a control module for toxic gas sensor heads with electrochemical sensors, or even PID sensor heads. Easy Installation and handling In case of extensive distance between sensor head and control room, it even provides two “sense” contacts to compensate for the voltage drop in the cable. Sensor heads and peripheral devices are very easy to connect, as all terminals are accessible from the front. The 24 V DC power supply and alarm signals run on a bus connector from one controller to the next. This bus structure supports also common alarm modules forming alarm groups, each with three relays of which the audible alarm relay that can be separately reset. It is not only a display unit for combustible gas sensors, it is also a relay station for transmitters operating as ‘source’ or as ‘sink’. An optional intrinsically safe repeater converts the 24 V DC loop power supply for transmitters into an intrinsically safe voltage. Compur Monitors GmbH & Co. KG Weißenseestraße 101 D-81539 München Tel.: 089/62038-0 Fax: 089/62038-184 Email: compur@compur.de Internet: http://www.compur.com Diese Informationen erfolgen nach bestem Wissen, gelten jedoch nur als unverbindliche Hinweise auch in Bezug auf etwaige Schutzrechte Dritter. Die vorgenannten technischen Daten und Anwendungshinweise befreien den Anwender nicht von einer eigenen Prüfung unserer Produkte und Vorschläge zur Anwendung im Hinblick auf Ihre Eignung für die beabsichtigten Verfahren und Zwecke. Die Anwendung unserer Produkte erfolgt außerhalb unserer Kontrollmöglichkeiten und liegt daher ausschließlich im Verantwortungsbereich des Kunden. Der Verkauf unserer Produkte erfolgt nach Maßgabe der allgemeinen Liefer- und Leistungsbedingungen der Compur Monito

GQMMR Monitors One common alarm module for up to 25 sensor heads The common alarm module coordinates the alarm signals generated by the single control modules. Easy installation The single alarm signals and the 24 V DC power supply are looped through a hardware bus, to which the common alarm module is connected too. As the control module, it is clipped onto the same DIN - rail. Common alarms, resettable audible alarm with alarm update function Every single alarm will generate a common alarm, and activate the audible alarm relay. This can be reset, but will be re - activated as soon as an...