Catalogs >
Comparato Nello S.r.l. >
Control unit for actuator in high-medium temperature

Control unit for actuator in high-medium temperature
4Pages

Catalog excerpts

Control unit for actuator in high-medium temperature - 1

Adjustment Control Units FIXED-POINT OR WEATHER COMPENSATION FOR HIGH/MEDIUM TEMPERATURE WITH 0-10V SETPOINT PROPORTIONAL INLET AND RTU MODBUS REMOTE MANAGEMENT USE Hot and cold fluid temperature control High/medium temperature heating systems (radiators, fan coils, etc.) with weather compensation Civil and industrial plants Interface with Building Management Systems (BMS) FUNCTIONS Fixed-point temperature control Weather compensation with external probe reading for high/medium temperature systems. Remote setting of the temperature setpoint with 0-10V signal Remote control with Modbus-RTU protocol APPLICATIONS The control unit can be combined with all Comparato’s motorised valves with 3-point control Adjustment Control Unit TECHNICAL FEATURES Power supply (110V on request) Input power Motorised valve control output 2 x triac protected by varistor 275 Vac Motorised valve control Motorised valve maximum consumption Protection degree Operational room temperature Flow temperature probe Electronic adjuster Temperature adjustment range Serial interface Communication protocol System pump relay flow rate Signal input impedance 0-10V Digital inlets Room thermostat • Hot forcing • Cold forcing

Open the catalog to page 1

Control unit for actuator in high-medium temperature - 2

Adjustment Control Units FIXED-POINT OR WEATHER COMPENSATION FOR HIGH/MEDIUM TEMPERATURE WITH 0-10V SETPOINT PROPORTIONAL INLET AND RTU MODBUS REMOTE MANAGEMENT OPERATION THREE SELECTABLE TYPES OF OPERATION FIXED-POINT REGULATION By means of a temperature probe, the control unit detects the fluid temperature and generates opening or closing commands for the motorised valve (not included), suitably calculated by the regulator with PID algorithm. This allows the system to maintain a constant temperature according to the setpoint value. Adjustment range -15°C to +90°C In case of power...

Open the catalog to page 2

Control unit for actuator in high-medium temperature - 3

Adjustment Control Units FIXED-POINT OR WEATHER COMPENSATION FOR HIGH/MEDIUM TEMPERATURE WITH 0-10V SETPOINT PROPORTIONAL INLET AND RTU MODBUS REMOTE MANAGEMENT REMOTE MANAGEMENT MODBUS RTU The control unit is equipped with a MODBUS RTU interface; using the RS485 serial connection, it is possible to modify all the operating parameters, send commands to the valve and receive information on the operating status. The control units can be connected to the modern Building Management Systems (BMS). The Modbus address table can be downloaded from www.comparato.com. FLOW SENSOR EXTHERNAL PROBE...

Open the catalog to page 3

Control unit for actuator in high-medium temperature - 4

Adjustment Control Units FIXED-POINT OR WEATHER COMPENSATION FOR HIGH/MEDIUM TEMPERATURE WITH 0-10V SETPOINT PROPORTIONAL INLET AND RTU MODBUS REMOTE MANAGEMENT ASSEMBLY The installer must arrange the installation wall according to the sizes shown on page 3. Three Ø5 mm plugs (not included) must be used to secure the control unit; they must be suitable for the type of wall chosen for installation. ACCESSORIES BRASS IMMERSION PROBE WITH CONNECTOR • Add "K" to the end of the code EXTERAL TEMPERATURE PROBE • Code RFSONDAE NOTE: socket not included Case material: plastic Thermal well material:...

Open the catalog to page 4