Size: 11 cm x 18cm x 9.3cm Weight: About 1.3 kg The CDL5 (ComNav Data Link) is a high-quality, entire band UHF external radio designed for GNSS RTK survey system. High power design will extend your RTK work region. Fully metal construction provides high performance and rugged dependability for the toughest environment. Designed for GNSS RTK Survey Systems Change Channels From 410-470 MHz in the Field Channel Spacing at 12.5 kHz Support 9600/19200 Air Baud Rate 6 User-defined Power Levels From 2W to 30W Anti-reverse Power Protection Super-rugged IP67 Proof Level and Robust Reliability Work as TX/RX/Repeater Mode Support Industry Common UHF Protocols EASY OF SETUP The CDL5 is designed to easily amount on all standard tripods and range poles. Advanced 10 channels can be easily changed even in the field. Different power level can be adapted as condition require: you can use high power for long range, and when in small work area, the lower power extends your battery working hours. REPEATER FUNCTION The CDL5 can seamlessly broadcast corrections to radio-enabled devices, and CDL5 is also capable of repeating real-time data. The work coverage can be enhanced by the function of repeaters, which enables you to reach inaccessible or obstructed locations. ©2021, ComNav Technology Ltd. All rights reserved. is the official trade mark of ComNav Technology Ltd., registered in People’s Republic of China, EU, USA and Canada. All other trademarks are the property of their respective owners. (April, 2021).

General Physical Frequency Range Channel Spacing Work Mode Frequency Stability Modulation System Air Baud Rate Protocol Type Adjacent Channel Rejection Ratio Forward Error Correction Sensitivity 410-470 MHz 12.5 kHz Channel Spacing ± 1.5 ppm Stability Half-duplex 1.5ppm GMSK 9600/19200 bps Selectable Transparent/South/Mac/TT450 - 55 dB Yes -117dBm BER 10-5 Data Connector 1 Serial Port (7-pin Lemo) Baud rates 38400bps (4800 bps to 115200 bps optional) Power Connector 2-pin Lemo port RF External 50 Ohm, N-TYPE female User Interface - Power button (for powering receiver) - Channel button - Power...