Phase monitoring relay RP33 3-phase monitoring of phase-neutral voltages Built-in adjustable time-delay Separate adjustments for minimum and maximum limits 1-pole relay output 8 A / 250 V AC AC supply voltages up to 3 x 415 VAC Made in accordance with the and EMC regulations The C-mac® module type RP33 meters its own 3-phase supply voltage, and checks that all 3 phase-neutral voltages are within the adjusted limits, and in that case, the output relay is activated. If one or more of the voltages are over or under the limits for a period of time, which exceeds the set delay, the relay releases. The module can operate from 80 to 120% of the nominal supply voltage. NOTE: The unit can only be used at 3 phases plus neutral. If neutral is not available, monitoring module type RP30 must be used instead. EMC and safety regulations. Emmision: EN 50 081 - 1 Immunity: EN 50 082 - 2 Safety: EN 60 730 Approvals: The units are produced in accordance with the CE og low voltage regulations. Technical data: Supply voltage: Supply frequency: Power consumption: Operation temp.: Humidity: Adjustments: Upper limit: Lower limit: Time-delay: Accuracy, scale: Upper and lower limit: Time-delay: Hysteresis: Indications: Green LED: Red LED: Max. load, relay: Ordering guide RP33: Supply 3 x 230 V (phase-phase) 3 x 380 V (phase-phase) 3 x 400 V (phase-phase) 3 x 415 V (phase-phase) Supply voltage connected Relay aktive 1-pole: 8 A - 250 VAC, ohmic load Potentiometer, scale 105 to 120% Potentiometer, scale 80 to 95% Potentiometer, scale 0 to 10 sec. Housing: NORYL-SE-1, grey, self-extinguishing Housing bottom: NORYL SE-1, GFN-2, black, self-extinguishing Terminals: Nickel-plated brass Weight: