The Extractor fastener tester is an essential tool in building industries, where it is important to validate and check for faulty fixing anchors on both new and old construction. This dedicated kit comes with a full range of accessories: - A Pull tester (with its calibrated gauge 1000lb or 2000lb, analog or digital) - Lifter foot for standard roofing screw LFS0250 (shank: 1/4” – Head: 5/8”) This EXTRACTOR 4000 is designed to test heavy duty anchors with a load up to 4000lb. It comes with: - A Pull tester (with its calibrated gauge 4000lb, analog or digital) - Lifter foot for standard roofing screw LFS4050 (shank: 0.5” – Max. Head: 1.0”) This EXTRACTOR 6000 is designed to test heavy duty anchors with a load up to 6000lb. It comes with: - A Pull tester (with its calibrated digital gauge 6000lb) - Lifter foot for standard roofing screw LFS6100 (shank: 1” – Max. Head: 2.0”) The principal objective in the use of a pull-out tester system is to validate the withdraw resistance of fixings on a substrate. During the last decade, the use of pull tester has become more and more widespread; and for good reasons. The usage of your pull tester is a very flexible method that can be used on various substrates: Brickwork, Concrete, Masonry and with almost any situation encountered during fixings process. Our EXTRACTOR fastener testers are specially designed for the following domains: - Measure the pull-out force to validate a safe working load - Check the correct installation of existing fixings - Measure the withdrawal resistance of fastener used for attachment of various components to various materials - Proof the holding power of anchors CONSTRUCTION AND SAFETY PULL TESTERS EXTRACTOR EXTRACTOR 4000 EXTRACTOR 6000 COM-TEN Industries - 6409 49TH Street North - Pinellas Park, FL, 33781 [email protected] - Tel: 727-520-1200 - Fax: 727-520-0299

The Safor portable tester is an accurate unit, designed for testing the pulling force of fixings prior to being put into service. Easily prevent accidents by testing on site the fixings to install end brackets and safety harness eyebolts. The Safor tester is specially designed for the following domains: - Testing of safety anchorages and Ringbolts - Proof the installation of fall arrest eyebolts & single point anchors. This dedicated kit comes with a full range of accessories: - A Pull tester (with its calibrated gauge 2000lb, analog or digital) - Ringbolt adaptor clevis - Lifter foot for NTB...