Foam Tester is an essential tool in roofing industries, where it is important to validate and obtain accurate stengths of polyurethane foam, and check for improperly installed foam. The Foam Tester is specially designed for the following domains: - Test the compressive yield strength of the foam - Validate the quality of SPF This dedicated kit comes with a full range of accessories: - A Pull tester (with its calibrated gauge 400lb, analog or digital) - Foam compression fixture The Deluxe Foam Tester kit includes the foam core cutter, an indispensable tool to cut your sample to the right size and a single arm crank to make your test quicker. The Deluxe Foam Tester is an essential tool in roofing industries, where it is important to validate and obtain accurate stengths of polyurethane foam, and check for improperly installed foam. This dedicated kit comes with a full range of accessories: - A Pull tester (with its calibrated gauge 400lb, analog or digital) - Foam compression fixture - Foam core cutter - Single arm crank with rotating handle The Foam application concept involves terminology that is a little different from normal fastener tester language. Foam Tester, is based on the principle of compression. During the installation or inspection on spray applied polyurethane foam (SPF), several possibilities/approaches can be considered; but with its Foam Tester Com-Ten Industries proposes to you the most cost and time efficient solution to perform the measurement in situ. The Foam Portable Tester has been designed by Com-Ten Industries for your quality test on spray applied polyurethane foam (SPF). It allows you to evaluate easily on the field the quality of the foam sample. With our foam tester, there is no more downtime waiting for laboratory results; do it yourself saving time and money. COMPRESSION FOAM TESTING PULL TESTERS FOAM TESTER DELUXE FOAM TESTER COM-TEN Industries - 6409 49TH Street North - Pinellas Park, FL, 33781 [email protected] - Tel: 727-520-1200 - Fax: 727-520-0299

Specially designed foam core cutter to cut foam samples with an area of 4in² (2.25in diameter). It makes the things easy and quick when it is time to take a sample of the foam. The foam sample is positioned in between two compression platens. The compression fixture is attached to a standard pull-out tester. A direct compression load is applied to the foam sample using the hand crank of the pull-out tester. The compressive force is displayed and registered on the readout gauge. FOAM CORE CUTTER HOW IT WORKS Visit our website www.pull-test.com to view our animations and choose the right solution...