This ADHOR R kit comes with a full range of accessories: - A Pull tester (with its calibrated gauge 400lb, 1000lb or 2000lb, analog or digital) - Lifter foot to attached discs LFS0250 - Two reusable 2.25" adhesion discs LFM225R - Two reusable 4" adhesion discs LFM400R The ADHOR kit comes with a full range of accessories: - A Pull tester (with its calibrated gauge 400lb, 1000lb or 2000lb, analog or digital) - Lifter foot to attached discs LFS0250 - Pack of 10 disposable 2.25" adhesion discs LFM225D Com-Ten is an instigator in the validation of installation of insulation membrane, with the UPLIFT Tester, and the measurement of the bonding strength of coatings, with the ADHOR Tester. These products are designed to proof the good installation and adhesion properties in the field. The ADHOR portable tester is ideal for your quality test on coating layer. It allows you to evaluate easily on the field the pull strength of your coating system on various substrates. The ADHOR is used in construction, roofing and in all the industrial and building companies when the bonding strength measurement is required. The UPLIFT portable tester was designed in conjunction with SPRI, for testing on the field the uplift resistance of adhesion. Easily test the attachment of the tile to underlayment and determine whether the uplift resistance performance meets the minimum wind load requirements. ADHESION and BONDING PULL TESTERS ADHOR kit ADHOR R kit COM-TEN Industries - 6409 49TH Street North - Pinellas Park, FL, 33781 [email protected] - Tel: 727-520-1200 - Fax: 727-520-0299 The ADHOR tester is specially designed for the following domains: - Measure the pull out strength between two layers after a repair or a new work - Check the adhesion strength between concrete structures and the existing substrate - Check the adhesion strength between additionnal overlays and existing substrate ADHOR SERIES

The UPLIFT portable tester was designed in conjunction with SPRI, for testing on the field the uplift resistance of adhesion. Easily test the attachment of the tile to underlayment and determine whether the uplift resistance performance meets the minimum wind load requirements. The Uplift portable tester is specially designed for the following domains: - Test the floor tiles installed on balconies - Check the adhesion of the roof covering - Proof the good installation of the waterproofing membranes - Perform a bonded pull test This dedicated kit comes with a full range of accessories: - A Pull...