Catalogs >
Columbia Marking Tools >
Double Acting Air Impact Marker Model 288 Operation Guide and Parts List

Double Acting Air Impact Marker Model 288 Operation Guide and Parts List
2Pages

Catalog excerpts

Double Acting Air Impact Marker Model 288 Operation Guide and Parts List - 1

Pneumatic Controls Installation Mounting: Mounting holes are located in the mounting bracket, and the use of 5/16-18 socket head cap screws with lock washers is required. The Model 288 markers require a sturdy, level platform for mounting. For optimum power, the marker should be mounted so that the stamp face is 2 1/8Ô to 2 3/8 away from the part to be marked for a 2 Խ stroke model. (2.125Ԕ to 3.875 for a 4 stroke model, etc.). ԃ Electrical Sequence for Double Solenoid Valve: To advance marker, energize solenoid AӔ. To return marker and reset, de-energize solenoid AӔ and energize solenoid BӔ. Electrical Sequence for Spring Return Valve: Ã Air Requirements: Model 288 is air powered for both the forward and reverse stroke. CMT recommends a 1/2 minimum shop airline. Maximum operating pressure of 100 psi, minimum operating pressure of 20 psi. Please note that the airline length between the valve and marker should not exceed 3Ԓ. The marker has two 3/8 NPT air ports. ԃ Adjustments: To advance marker, energize solenoid AӔ. To return marker and reset, de-energize solenoid AӔ after part is marked. Speed Control Adjustment: Adjust speed control ÓR to control speed of retract motion. DO NOT install speed control on forward (rod) port of marker. ԃ Note: For most efficient operation, electrical signal energizing solenoid AӔ should be very short, approximately .06 to .10 seconds. Suggested Pneumatic Control Diagram To regulate marking pressure, adjust FRL (Filter/Regulator/Lubricator unit). Sold separately. Increase air pressure to mark deeper. Decrease air pressure to mark lighter. Maintenance > MarkerSol AӔ 1/2 Shop AirStandard 4-Way Valve FRL Combo Unit Sol ԓB3/8Ԕ Tube 3/8 Tube ԓR Shut off all air and electrical power prior to performing any and all maintenance. > ԃ Lubrication: Add 10W "light" industrial hydraulic oil to lubricator bowl and adjust oil flow to approximately 1 drop for every 30-50 cycles. The Model 288XX-XX-XX-X-NL is a non-lube system and does not require any lubrication. > Air Filter: Check and clean /change as required. The frequency of cleaning/changing is dependent on environment and plant air system. Do not allow excess water to fill filter bowl. >

Open the catalog to page 1