REVIBLOC SPEED REDUCER 76001 -1/2 Fiche Techniclue - Technical Data Sheet 02-2018 spheroidal cast iron) Primary drive • The primary drive must be at an angle of 90° with the line which links the axis of output and input of the reducer. (See drawing below). • The output speed can be changed putting another pulley on the primary shaft. • Variable output speed is obtained by changing the primary transmission with a beltdrive variation group. Back-Stop (on request) • Avoids unwanted rotation (ex : elevator) • Rotation is determined by facing the input shaft : if the output shaft turns clockwise, it is a "right" rotation (type D) ; otherwise it is a "left" rotation (type G). Please specify the type with the order. Torque Arm • It must be installed to work in tension and must be at an angle of 90° with the big axis of the reducer (see drawing opposite). • For a left rotation it is located on the right side and inversely • For rotation in both ways (on high shocks), it is advisable to install an arm on both sides. Vertical position • If the reducer is to be used in a vertical position, please specify it in the order (type V). • These type of reducers can work in an horizontal position taking into account the position of the fillers and considering that filling must be done in accordance with the new position. RV 180 . 4 : REVIBLOC Reducer size 180, ratio 4:1 RV 150V . 15 : REVIBLOC Reducer size 150, used for vertical position, ratio 15:1 RV 250D . 25 : REVIBLOC Reducer size 250, with holdback right rotation allowed, ratio 25:1 RV 105S . 25 : REVIBLOC Reducer size 105 with special parts (no standard hollow

REVIBLOC SPEED REDUCER 76001 - 2 / 2 Fiche Technique - Technical Data Sheet COLMANT CUVEUERrps member of SANOK RUBBER GROUP 02-2018 member of SANOK RUBB