Joined but independent, these two chambers of Excal 140 "hot cold humid" type enable window panes or other materials to be tested under two different climatic conditions which could, eventually, stand for outside and inside atmospheres. Frequently used to test insulation or building materials, this equipment is also used to check gasket or assembly tightness. The central interface can be easily reached by pulling aside the chambers which are equipped with casters and handles. When the chambers are fully open, it can be accessed from both sides and it is at human height. SPECIAL Dual-climate chamber The central interface is custom-designed to fit tests requirements and to receive a specific tool-holder. This tool-holder is fixed on the interface and easily removable, so it can be adapted to the different tests requirements. The piloting, ensured by Spirale 3, makes it possible to synchronize or desynchronize setpoints in time so the required conditions are perfectly controlled. In "Dual-climate" mode, the piloting, as well as the programming, is assumed by one of the two touch Panel PC. This function enables the commands and the recordings to be centralized on the same support. These two chambers being linked only by a network cable, they can be quickly disconnected and used as classical climatic chamber. This association can be carried out with other volumes (de 138 à 1800 l) of the Excal range. Zone du Bedat - CS 50067 - 33652 St Médard d'Eyrans Cedex- France www.climats-tec.com tel. : +33 (0)5 56 20 25 25 - fax : +33 (0)5 56 78 43 97 [email protected]

Technical features Temperature range from +180°C to -45°C Hygrometry from 10 to 98% humidity within the temperature range from +20°C to +90°C characteristics subject to change without notice and not contractual Speed variation 15°C/min from +80°C to -40°C and the other way round Zone du Bedat - CS 50067 - 33652 St Médard d'Eyrans Cedex- France www.climats-tec.com tel. : +33 (0)5 56 20 25 25 - fax : +33 (0)5 56 78 43 97 [email protected]