Catalog excerpts
Nominal torque Minimal torque Rotor inertia Heat dissipation is the mechanical power (P = on) maximum allowable Application Notes Mounting must be made without any stress. Lubricated for life (other internal lubrication not allowed). The shaft should be lubricated upon assembly, to prevent seizing. Low DC current power supply for coil. The standard device is designed for horizontal shaft orientation, and a minimal speed of 60 RPM. Maximum speed is 2000 RPM (without exceeding the max. heat dissipation capability). For Engineering application, please contact our technical support. In normal use, the outside temperature of the device can increase up to 100°C without damage.
Open the catalog to page 1
Motion Controls • If the device is to be used in dusty, humid or corrosive environment, special protection needs to be considered. Recommended mounting principles Parallel mounting Rotating shaft Fixing flange Fixing flange ©Cleveland Motion Conrols, Inc. 7550 Hub Parkway • Cleveland, Ohio 44125 www.cmccontrols.com • email: literature@cmccontrols.com
Open the catalog to page 2All Cleveland Motion Controls catalogs and technical brochures
-
EMAG Power Block (PB2)2 Pages
-
EMAG 2602 Pages
-
EMAG 1502 Pages
-
EMAG 902 Pages
-
EMAG 502 Pages
-
EMAG 26 Clutch2 Pages
-
EMAG 26 Brake2 Pages
-
EMAG 9 Clutch2 Pages
-
EMAG 9 Brake2 Pages
-
EMAG 4H Clutch2 Pages
-
EMAG 4 Clutch2 Pages
-
EMAG 12 Pages
-
EMAG 4 Brake2 Pages
-
EMAG Series Summary1 Pages
-
Classic Slim Cell Transducer6 Pages
-
Classic UPB Transducer4 Pages
-
Classic CR Transducer4 Pages
-
Classic Cartridge Transducer4 Pages
-
TENSION TRANSDUCERS4 Pages
-
Classic Tension Transducers4 Pages
-
Cleveland-Kidder ®Ultra6 Pages
-
Cleveland-Kidder ® Ultra4 Pages
-
Soft PLC Brochure6 Pages
-
SD 5000 Digital Servo Drive6 Pages
-
Encoder Product Guide4 Pages
