video corpo

Oil Pump Set
12Pages

{{requestButtons}}

Catalog excerpts

Oil Pump Set - 1

Simplex & duplex technology

Open the catalog to page 1
Oil Pump Set - 2

Simplex No. 2 thru 6 Oil 75 to 1600 GPH Cleaver-Brooks Simplex Oil Pump Systems are designed to deliver No. 2 thru No. 6 fuel oil to any operation which requires an oil supply. These systems are assembled, wired, and tested units suitable for light or heavy fuel oils. Capacities range from 75 to 1600 gallons per hour. Direct drive gear type pumps, with integral relief valves are used for No. 2 and 5 oils. No. 6 oil systems use a screw type pump with a separate relief valve. Pump rating is based on 50 psi discharge pressure, other pressures are available, please consult the factory. Suction...

Open the catalog to page 2
Oil Pump Set - 3

Controls • 120/1/60 control circuit • Control panel mounted to base • Motor starter • Signal light (power on) • Switch (on-off) Suction Side • Manual valve • Simplex strainer • Vacuum gauge with isolator Other Equipment • Drip pan base with drain • Pump and Motor • Pump relief valve (integral on No. 2-5 oil) • Check valve (optional) Ordering Information • Oil pump system number • Oil grade and viscosity • Flow rate • Electrical characteristics Discharge Side • Manual valve • Volume control valves • Pressure gauge with isolator Motor HP and RPM are subject to change based on pump selection....

Open the catalog to page 3
Oil Pump Set - 4

Simplex No. 5 and 6 Oil 75 to 1500 GPH Cleaver-Brooks Simplex Oil Pump and Heater Systems are designed to deliver No. 5 or No. 6 fuel oil to any type of operation which requires a heated oil supply. The package performs three functions that are essential to efficient heavy oil operation: transferring oil from the supply and boosting the pressure to that required by the burner(s), straining oil to remove solids which would increase wear on pumps, valves and nozzles, and temperature regulation to control fuel oil viscosity. Capacities range from 75 to 1500 gallons per hour. The oil heater is...

Open the catalog to page 4
Oil Pump Set - 5

Controls • 120/1/60 control circuit • Control panel mounted to base • Motor starter • Signal light (power on) • Switch (on-off) Suction Side • Manual valve • Simplex strainer • Vacuum gauge with isolator Discharge Side • Manual valve • Volume control valves • Pressure gauge with isolator • Steam heat exchanger with: • Oil temperature regulator • Steam strainer • Steam trap • Steam globe valve • Heat exchanger relief valve • Manual vent valve • Thermometer 50°/-300°F Other Equipment • Drip pan base with drain • Pump and motor • Pump relief valve (integral on No. 2-5 oil) • Check valve...

Open the catalog to page 5
Oil Pump Set - 6

Duplex No. 2 thru 6 Oil 75 to 1600 GPH Cleaver-Brooks Duplex Oil Pump Systems are designed to deliver No. 2 thru No. 6 fuel oil to any operation which requires an oil supply. The duplex system assures a constant supply of filtered oil with the second pump available for standby service. This type of service is essential in applications where systems cannot be interrupted to clean strainers or service pump. The Duplex Oil Pump Systems are assembled, wired and tested units suitable for light or heavy fuel oil. Capacities range from 75 to 1600 gallons per hour. Direct drive gear pumps, with...

Open the catalog to page 6
Oil Pump Set - 7

Other Equipment • Drip pan base with drain • Pumps and Motors (2) • Pump relief valves (integral on No. 2-5 oil) (2) • Check valves (optional) Ordering Information • Oil pump system number • Oil grade and viscosity • Flow rate • Electrical characteristics Controls • 120/1/60 control circuit • Control panel mounted to base • Motor starter (2) • Signal lights (pump 1 and 2) • On-Off and pump selection switch Suction Side • Common suction • Manual valves (2) • Simplex strainers (2) • Vacuum gauge with isolators (2) Discharge Side • Common discharge • Manual valves (2) • Volume control valves...

Open the catalog to page 7
Oil Pump Set - 8

Cleaver-Brooks Duplex Oil Pump and Heater Systems are designed to deliver No. 5 or No. 6 fuel oil to any operation which requires a heated oil supply. The package performs three functions that are essential to efficient heavy oil operation: transferring oil from the supply and boosting the pressure to that required by the burner(s), straining oil to remove solids which would increase wear on pumps, valves and nozzles, and temperature regulation to control fuel oil viscosity. Capacities range from 75 to 1500 gallons per hour. The duplex system assures a constant supply of heated oil for...

Open the catalog to page 8
Oil Pump Set - 9

Controls • 120/1/60 control circuit • Control panel mounted to base • Motor starters (2) • Signal lights (pump 1 and 2) • On-Off and pump selection switch Suction Side • Common suction • Manual valves (2) • Simplex strainers (2) • Vacuum gauge with isolators (2) Discharge Side • Manual valves (2) • Common discharge • Volume control valves (2) • Pressure gauge with isolator • Steam heat exchanger with: • Oil temperature regulator • Steam strainer • Steam trap • Steam globe valve • Heat exchanger relief valve • Manual vent valve • Thermometer 50°/-300°F Other Equipment • Drip pan base with...

Open the catalog to page 9
Oil Pump Set - 10

System Specifications Fuel Oil Pump Systems General Furnish one Fuel Oil Pump Set, designed to pump _________ GPH of No. _________ oil at _________ PSI at not more than _________ ft. total lift including friction. Set shall be a factory engineered and fabricated assembly, as manufactured by Cleaver-Brooks Model No. _________, and shall include the following components: Oil Strainer _________ simplex _________ duplex cast iron strainer located at oil inlet. Pump - Electric Driven Heavy duty pump rated _________ GPH at _________ PSI, operating at 1750 RPM. Pumps for No. 6 oil to be screw...

Open the catalog to page 10
Oil Pump Set - 11

Fuel Oil Pump and Heater Systems General Furnish one Simplex Fuel _________ or Duplex Fuel _________ Oil Pump and Heater System, designed to transfer _________ GPH of _________ (No. 5 or No. 6) oil at _________ PSI with a temperature rise of _________ °F minimum inlet temperature. System, Model No. _________, shall be manufactured by Cleaver-Brooks and shall include the following components: Fuel Oil Heater Shell and tube type Paracoil heater with relief valve, manual vent valve and removable bundle, with capacity to heat _________ GPH No. _________ fuel oil from _________°F to _________...

Open the catalog to page 11

All Cleaver-Brooks catalogs and technical brochures

  1. LCS150e.1

    2 Pages

  2. LCS250e.1

    2 Pages

  3. LevelMaster

    4 Pages

  4. Model 4

    4 Pages

  5. Model 5

    4 Pages

  6. PCS140e.1

    2 Pages

  7. ProFire-D

    8 Pages

  8. ProFire-NTH

    4 Pages

  9. ProFire-S1

    4 Pages

  10. Stack Damper

    2 Pages

  11. LC ClearFire

    8 Pages

  12. SCR

    4 Pages

  13. FLX Flextube

    8 Pages

  14. ADAC

    2 Pages

  15. 4WI - CBLE

    8 Pages

  16. CBR

    4 Pages

  17. ICB

    8 Pages

  18. CBL

    4 Pages

  19. Ohio Special

    4 Pages