Rack Mount Table-Top NMHC Analyzer
8Pages

Rack Mount Table-Top NMHC Analyzer Non Methane Hydrocarbon FID 109A © J.U.M. Engineering 1989/2020 The 109A is a rack mount and table top, fully heated FID analyzer for the continuous, simultaneous determination of the gaseous mass concentration of Methane Carbon, Non Methane Organic Carbon and Total Organic Carbon (TVOC) using the Dual Flame Ionization Detector method. Full Compliance confirmed: ✗ ✗ ✗ EN ISO 25140 and VDI 3481 for the Automatic Methane/Non Methane Concentration Measurement QAL1 EN 14181-EN ISO 4659 and EN 12619:2013 for Total Organic Carbon (VOC/TGOC) USA EPA Method 25A for Total VOC/TGOC and Automatic Methane/Non Methane Concentration Low cost of ownership. Low fuel gas consumption. Combustion air supply for the FID-detector is built in. No external cylinder for synthetic air is needed. To prevent well known HC hang up (memory effect) and related sample drifting, the heated sample line can easily be connected inside of the heated oven. This prevents any cold spot and any related HC condensation, (Back purge feature not available for 109A-OVE) The 109A is the most used HFID analyzer throughout the stack testing industry for measuring the Continuous, Simultaneous Methane, Total Hydrocarbon and Non Methane Hydrocarbon Concentration Printed on 100% Recycled Paper

109A Heated FID Gaseous NMGOC Analyzer General: Analyzer fully complies with EN ISO 25140. THC (TVOC) circuit fully complies with QAL1 (EN 14181-EN ISO 14659), with EN 12619:2013, in USA with EPA Method 25A and Method 503 The 109A is the only available heated non methane gaseous organic carbon NMGOC (NMHC) FIDanalyzer with an internal permanently installed sample filter to be cleaned by pack purge with compressed air or nitrogen. This feature cleans the sample filter and the sample line at the same time and nearly eliminates sample related drifting when automated. A stack filter probe is...

109A Heated FID Total Continuous Gaseous NMGOC Analyzer Made in Germany 1st Sampling Choice: Maintenance free, permanently installed sample filter back purge system allows filter to be cleaned without dismantling (automatic back purge optional) 2nd Sampling Choice: Disposable sample filter which is easily accessible in the rear panel without special tools. This optional available feature reflects a 20% price advantage. All components in contact with sample are fully heated and digitally maintained at 190°C Built-In sample pump Built-in combustion air supply, no extra burner air bottle...

109A Heated FID Gaseous NMGOC Analyzer Principle of Operation The Heated Flame Ionization Detection (HFID) method is used to determine the presence of total organic carbon concentrations in gaseous samples. Two detectors are used in parallel, one for TGOC and one for Methane Carbon (MC). Burning hydrocarbon-free hydrogen in hydrocarbon-free air produces a negligible number of ions in the detector. Once a sample which contains any organic carbon matter is introduced into this flame, a very complex ionization process is started. This process creates a large number of ions. A high polarizing...

109A Heated FID Total Continuous Gaseous NMGOC Analyzer OPTIONAL FUEL SHUT OFF VALVE OVEN TEMP. 190 °C IGNITE ADJ. FUEL CAPILLARY FUEL CAPILLARY SAMPLE PUMP SAMPLE IN FILTER SAMPLE VALVE SAMPLE PRESSURE DUST FILTER AMBIENTAIR IN AIR PUMP OPTIONAL STAND BY AMBIENT AIR IN DUST FILTER Complete flow diagram shown with standard back purge sample filter OPTIONAL FUEL SHUT OFF VALVE OVEN TEMP. 190 °C IGNITE ADJ. FUEL CAPILLARY CATALYST REPLACEABLE SAMPLE FILTER FUEL CAPILLARY BYPASS SAMPLE PUMP SAMPLE PRESSURE AMBIENT AIR IN DUST FILTER Complete flow diagram shown with alternative disposable...

6 [8] Heated FID Continuous TGOC & NMGOC Monitoring Solutions, Since 1973

109A Heated FID Total Continuous Gaseous NMGOC Analyzer OVE 9 Quick change, disposable 2 micron sample filter housed in the heated oven in stead of back purge sample filter (A 20% Price Advantage) AMU 9 Automatic controlled range change with range identification FSS 9 For portable applications; Small and safe FID-Fuel Storage; Low pressure, 50 liter metal hydride Hydrogen fuel storage cartridge. Optional pressure regulator and pressure gauge mounted on 1/4“ Swagelok quick connector. Refill from large cylinder is safe and can be performed with standard 0 to 10 bar (0 to 1 MPa) rated gas...

109A Heated FID Gaseous NMGOC Analyzer Questions and Answers about the low pressure rechargeable Hydrogen storage system Q: Is the new fuel gas storage a high pressure cylinder? A: Actually no, it is not! The new hydrogen FID Fuel Gas Storage System is a Metal Hydride storage. It is charged at a low pressure of 1 MPa (10 bar), operating at pressures below 0.08 MPa (8 bar). The tank withstands pressures of over 200 bar. Q: Is the new hydrogen storage a pressurized gas tank? A: No, it is not a gas tank. In this hydrogen fuel gas storage system, hydrogen is stored in form of solid metal powder...