Operating the LPS II-power supply with the remote
1 / 2Pages

Operating the LPS II-power supply with the remote Using 12 V Push the button which will light up green, now 230 V is active. Jump start Push the button which will light up green, now 12 V is active. i If there is no consumption for 60 minutes the 230 V switches off automatically in order to save power. At the lower part of the remote a status indicator gives the charging status. Status is for both the LPS as well as any additional batteries connected. i 230 V is active during driving if there is a key wake-up function and is automatically switched off after 60 minutes in case there is no consumption. LPS- Power Supply can jump start a dead battery. 2 Push the button which will flash green for 5 minutes. 3 After 5 min. the LED diode stops flashing - now the car will start.

In case of malfunction 1 Check if the RCD-relay is active h When contacting your supplier i State the serial number which can be found on the side of the RCD-relay i State possible error code 2 Check battery status