Catalogs >
CIRCUTOR >
CR Series

CR Series
1Pages

Catalog excerpts

Current injection relay tester Description The CR-50, CR-100 and CR-250 units include specially designed current generation systems that can check the current / time trigger curve of automatic switches and indirect protection relays. Its operation principle is based on the injection of an alternating current that can be adjusted throughout the circuit being tested with a short-circuit cable loop. The connection of an auxiliary contact of the switch being tested can be used to measure the trip time for each current selected. The test is easily carried out with a start-stop control. An automatic meter is responsible for taking the measurements and showing them on the display. Features Features Power supply Current generation system Insulated, short-circuit potential, adjustable with the controls on the front of the unit Overload capacity Nominal power Current generation system We can highlight that the unit can be used to check the full protection system, including the current transformer in the case of indirect relays, since the current can be injected on the primary side of these transformers. After the test, a digital display automatically shows the value of the current injected and the trip time until the RESET button is pressed. Current measurement digital instrument CR-50: 1 % of the reading / ± 2 digits CR-100: 0.5 % of the reading / ± 1 digits CR-250: 0.5 % of the reading / ± 1 digits Time measurement Digital clock Measurement range Test method Start: with start button Automatic stop: aux. contact open or closedManual stop: with stop button Construction features Dimensions Standards IEC 348, IEC 664, UNE 20 553, VDE 0110 (*also see the regulations to check the test methods) References Description 50 A relay check system (case version) 100 A relay check system (case version) 250 A relay check system

Open the catalog to page 1