SLR-434M

SLR-434M

Product catalog summary
Overview
The SLR-434M is a compact, narrowband embedded radio modem designed for the 434 MHz ISM band. It utilizes LoRa® technology to provide long-range communication at low power and bit rate, making it suitable for challenging RF environments. The modem supports both serial data transmission and switching signals through its 8 IO ports.

Key Features
  • Operates in LoRa and FSK modes, offering flexibility in communication methods.
  • CE/UKCA marked for compliance.
  • Low power consumption suitable for battery operation.
  • Compact design with dimensions of 40 x 29 x 6.2 mm and a weight of 13 g.
  • Available for 429 MHz operation in Japan.

Applications
  • Data transmission and control in building air conditioning systems.
  • Monitoring debris flow at mudslide control dams.
  • River water level and dam gate management.
  • Greenhouse temperature and humidity monitoring and control.
  • Monitoring of tunnels and bridges.

Technical Specifications
  • Communication: Simplex, Half duplex with F1D emission type.
  • Modulation: 2-FSK or LoRa.
  • RF Output Power: 10 mW (SMA / 50 ohm).
  • RF Bit Rate: 4,800 bps (FSK) or 15 to 245 bps (LoRa).
  • Frequency Range: 433.0750 to 434.7750 MHz.
  • Operating Temperature: -30 to +70°C.
  • Receiver Sensitivity: -115 dBm (FSK), -133 dBm (LoRa).
  • Supply Voltage: 3.5 to 5.0 V.
  • Supply Current: 29 mA (TX), 17 mA (RX).
  • Serial Communication: RS232, 19,200 bps, asynchronous UART.

Compliance and Standards
  • Complies with EN 300 220 standard.
See more

Catalog excerpts

SLR-434M-1

Low Power Radio Modem The SLR-434M is a narrowband embedded radio modem for the 434 MHz ISM band. Compact and designed for ease of use, it incorporates LoRa® technology to achieve extremely long range at low power, albeit at low bit rate. Its superior sensitivity allows the possibility of communication into areas once considered difficult for RF to penetrate. The SLR-434M uses a dedicated command system with a simple to use proprietary protocol. In addition to serial data transmission, the module also includes 8 x IO ports for switching signals allowing transmission of signals from sensors or for driving relays. Narrowband CE / UKCA marking Extremely long range operation achieved by LoRa mode. Higher resistance to urban noise, enabling long range operation Switchable between FSK mode and LoRa mode UART interface Transmission of up to 8 switching signals Low power consumption makes battery power operation possible Compact size 429 MHz (Japan) available Data transmission, building air conditioning control Debris flow monitoring at mudslide control dams River water level / dam gate management Greenhouse temperature / humidity monitoring and control Monitoring of tunnels and bridges Applicable standard Communication method Simplex, Half duplex Emission type Operating temperature Channel spacing Receiver sensitivity Supply voltage -115 dBm (FSK), -133 dBm (LoRa 128 chip) (PER 1% with the user data of 45 bytes or less) 3.5 to 5.0 V Supply current 40 x 29 x 6.2 mm (Not including antenna connector) Serial interface Communication method Asynchronous / UART Data speed Flow control Hardware: RTS / CTS pin Software: Xon / Xoff not used Other parameters Data length: 8 bit, Parity: None, Stop bit: 1 Specifications are subject to change without prior notice The SLR-434M contains a Semtech's LoRa wireless RFIC. The LoRa® Mark and LoRa Logo are trademarks of Semtech corporation. ® Sales Division 7557-1 Hotaka, Azumino, Nagano 399-8303, Japan Tel:+81-(0)263-

 Open the catalog to page 1
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.