Miniature Series 07 General Purpose Regulator 1/8" and 1/4" Port Sizes q Compact design q Full flow gauge ports q Low torque, non-rising adjusting knob q Snap action knob locks pressure setting when pushed in q Standard relieving models allow reduction of outlet pressure even when the system is dead-ended q Can be disassembled without the use of tools or removal from the air line Ordering Information. Models listed include PTF threads, relieving diaphragm, 5 to 100 psig (0.3 to 7 bar) outlet pressure adjustment range*, with gauge. † Approximate flow at 100 psig (7 bar) inlet pressure, 90 psig (6.3 bar) set pressure and a droop of 14.5 psig (1 bar) from set. Alternative Models Port Size 1/8" 1/4" Option Not applicable Option Standard Low flow seat * Outlet pressure can be adjusted to pressures in excess of, and less than, those specified. Do not use these units to control pressures outside of the specified ranges. Threads PTF ISO Rc taper ISO G parallel Outlet Pressure Adjustment Ranges* Substitute 1 to 10 psig (0.1 to 0.7 bar) A 5 to 50 psig (0.3 to 3.5 bar) E 5 to 100 psig (0.3 to 7 bar) K 5 to 125 psig (0.3 to 8.6 bar) L Gauges With Without Diaphragm Relieving Non relieving See Section ALE-24 for Accessories Relieving

General Purpose Regulators Typical Performance Characteristics Technical Data Fluid: Compressed air Maximum pressure: 300 psig (20 bar) Operating temperature: -34° to 150°F (-35° to 65°C) * FLOW CHARACTERISTICS PORT SIZE: 1/4" INLET PRESSURE: 150 psig (10 bar g) RANGE: 5 to 100 psig (0.3 to 7 bar) * Air supply must be dry enough to avoid ice formation at temperatures below 2°C (35°F). Typical flow at 150 psig (10 bar) inlet pressure, 90 psig (6.3 bar) set pressure and a droop of 15 psig (1 bar) from set: 1/8" ports: 14 scfm (6.5 dm3/s) 1/4" ports: 15 scfm (7 dm3/s) Gauge ports: 1/8" PTF with...