IMS MULTI AXIS SCANNER The CIMBRIA IMS MULTI AXIS SCANNER is specially designed to profile very big grain silo bins and storage bunkers. The unit can operate as a single unit on the IMS software platform or as a group within big storage bunkers where coverage can be overlaid to prevent “blind spots”. Profile scans can be done on a timed schedule or with the Dynamic Profiler in the IMS software. The Dynamic Profiler compares certain points on the profile against previous movements and manages the profile scans accordingly. All information is recorded into the IMS software where accurate volume is calculated and tonnages are reported. OUTPUT POWER: DIVERGENCE: MAX RANGE: MIN RANGE: RESOLUTION: SUPPLY VOLTAGE: POWER USAGE: DATA INTERFACE: OPERATING TEMP: WEIGHT: PROTECTION: 650nm laser diode (Red) Class 2 Conforming to IEC825-1 /EN60825, Class 2 (FDA21 CFR) < 1mW 0.6 mrad 50M (>100 M with reflective target) 200 mm 1 mm 1VDC to 30VDC (Reverse polartity protected) <1.5W RS232 -9600,8,N,1 (ASCII) -10°C to +60°C 850 g IP65 A) Motor Housing B) Gear Housing C) Mounting Bar D) Scanning Laser E) Power and Data Conduit TILT DEFLECTION: ROTATIONAL RES: CONNECTOR: SUPPLY VOLTAGE: POWER USAGE: DATA INTERFACE: OPERATIONAL TEMP: WEIGHT: PROTECTION: Copyright © - The right to alterations is reserved 10/10 LJE Cimbria Unigrain A/S . Praestejorden 6 . 7700 Thisted . Denmark . Tel. +45 9617 9000 . Fax +45 9617 9299 Web: www.cimbria.com . E-mail: [email protected] . Member of the Cimbria Group of C