300 with field diaphragm φ10mm 200 with field diaphragm φ10mm 300 with field diaphragm φ10mm 300 with field diaphragm φ10mm 300 with field diaphragm φ10mm 200 with field diaphragm φ 200 with field diaphragm φ 200 with field diaphragm φ

IR-CZ SERIES ,.μm) uses a chopper-less structure

IR-CZ SERIES C / C or 0.015% / C of measured value whichever larger φ20mm or φ10mm with field diaphragm

Sediment at furnace hole Window glass ! Temperature output 4-20mA Lack of view alarm output Dust / particles Furnace wall Analog input (Connector type only) Input signal: 4 to 20mA DC Selectable from emissivity remote setup or automatic emissivity calculation Contact input (Connector type only) 1 point: Peak hold reset or Sample hold or Laser on/off Dry contact or Open collector Contact output (Connector type only) 2 points: High (low) alarm or Error signal (self-diagnostic) or Dirty lens detection (2-colour model) Open collector 30V DC, Max. 50mA Laser targeting Built-in semiconductor laser...

IR-CZ SERIES "#" ■ The soft protective case IR-ZZCS is an exclusive accessory for the IR-CZ series to protect the thermometer from smoke, dust, etc at the installation site. This unit provides air-purge to remove smoke and dust for keeping the lens clean. Use clean instrumentation dried air. (Common use for connector type and terminal type) ■ The hard protective case IR-ZCCHT is an exclusive accessory for the IR-CZ series to protect the thermometer from high-temperature, humidity, smoke, dust, fume, etc. This unit provides air-purge and water-cooling to operate the thermometer properly in harsh...

Cleaning plug