CA 6651 Test adapter for electric vehicle charging stations Check the safety and operation of the charging station with an installation tester simply by simulating the presence of an electric vehicle with the adapter for interfacing on the socket of a charging station For your own and your vehicle’s safety, check the charging station regularly according to the applicable standards: z Test adapter for mode-3 AC vehicle charging stations equipped with a cable with a type-2 connector z Simulation of vehicle status (Control Pilot signal) z Switching between the different charging currents from 13 to 63 A (Proximity Pilot status) z Connection to view the status of the signal (Control Pilot signal) z PE pre-test to check that there is no hazardous voltage present in relation to the earth (PE) z Presence of phases L1/L2/L3 indicated by 3 LEDs z Adapter alone for verification of station operation z Adapter with installation tester to check the electrical safety of the charging station

OUR INTERFACE solution for mode-3 AC charging stations equipped with a type-2 connector VEHICLE STATUS Electric vehicle not connected, charging station not supplying energy Electric vehicle connected, not ready to charge, charging station not supplying energy Electric vehicle connected, ventilation not necessary, charging station ready to charge Electric vehicle connected, ventilation necessary, charging station ready to charge CA 6651 TEST ADAPTER FOR MODE-3 AC VEHICLE CHARGING STATIONS WITH TYPE-2 CONNECTOR PE PRE-TEST PP simulation CP status CP/PE error Earth fault PE error Protection / Admissible...